Electronics Forum | Sun Oct 21 22:05:01 EDT 2018 | srini1904
Hello, We have Dek 248 Icon i2 semi auto screen printer. This machine was not in use for long time and Bios battery was dead. We replaced Bios battery and now date are correct. Issue is its not communicating to control board. Suspecting Bios setti
Electronics Forum | Sat Nov 06 06:41:11 EDT 2021 | ttheis
The DEK248 we had at one time was pretty compact but it did not have automated alignment- just a semi-manual camera/monitor stencil alignment process.
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Tue Mar 09 19:45:34 EST 1999 | Peter van den Berg
We're looking for a replacement for Panahost. Any suggestions for alternative packages that will enable us to upload/download to Panasert Machines? In preference we want a communication package that uses code operated switching (COS) to at least 20
Electronics Forum | Fri Oct 02 11:33:49 EDT 2009 | floydf
I've got a Universal axial machine with an 8221 controller on it. It stopped communicating to the monitor. Also, when I start it up the run light comes on for a second and then goes off. Does anyone have any ideas on where I can find information for
Electronics Forum | Wed Nov 13 09:26:10 EST 2019 | bobpan
I think it has something to do with the communication between the 2 computers. Plug a monitor into the back computer rack and see if there is an error showing when its trying to boot up. Its been a long time....so dont quote me....ha
Electronics Forum | Thu Mar 11 01:12:24 EST 1999 | M. Faisal
| We're looking for a replacement for Panahost. | Any suggestions for alternative packages that will enable us to upload/download to Panasert Machines? | In preference we want a communication package that uses code operated switching (COS) to at le
Electronics Forum | Sat Nov 21 07:57:48 EST 2015 | micropak
Actually I from the SC I am able to ping both the MC and the LC. By switching the monitor display the MC shows text the last line of which says"Config completed enabling task". The ICOS display is a red cross hair. All the axis cards show green LEDS.
Electronics Forum | Thu Nov 14 15:46:28 EST 2019 | assuredtech
> I think it has something to do with the > communication between the 2 computers. Plug a > monitor into the back computer rack and see if > there is an error showing when its trying to boot > up. Its been a long time....so dont qu
Electronics Forum | Wed Jun 11 10:27:33 EDT 2003 | caldon
Frank-In addition (Dave gave some good scoop) we use a Pyrex Glass board to run through the wave. This is useful as you can see through the board .....you can watch the flux coverage, preheat, and Wave (be it Chip, lamda, or??) as it goes through the
