Electronics Forum | Sat Oct 08 17:47:33 EDT 2016 | goldentech
Dek 248.cerd tooling table stuck in the up position,any one can help. Thanks, Tom
Electronics Forum | Tue Dec 03 07:57:27 EST 2002 | pjc
Price of DEK 248 and MPM UP100 are about the same, $22-36K range. MPM UP100 has programmable squeegee pressure. Precise, repeatable results with less operator involvement. Pressure parameters saved in board program file. DEK 248 has manual microm
Electronics Forum | Mon Jun 23 15:28:41 EDT 2014 | globalpowerproducts
I have a 1997 DEK 248 screen printer that does not have the magnetic suction cups. Any thought on where i can find these or suggestions on how to secure the board on the table?
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Sat Jan 15 16:33:13 EST 2011 | dilogic
Our DEK248 started to behave oddly - squeegee speed can't be controller anymore. It always moves with max.speeed or something close to that, regardless of the current settings. Also, the table sometimes shoots out with very high speed. I am suspectin
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Wed Aug 20 06:33:16 EDT 2008 | benefon
If this is machine is of the same type of construction as our 248 with the pneumatic table sliding mechanism, check the 'table out sensor' in the 'digital inputs' section of the diagnostics menu. rgds AR
