Electronics Forum | Fri Jun 03 20:21:56 EDT 2016 | sonavc
Thanks , I fix this problem. Now I know the boards stop near by camera.
Electronics Forum | Mon Mar 11 13:02:07 EDT 2024 | denism
Hi, Did you check power cable to the camera? It is can be the reason.
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Tue Jul 30 12:30:21 EDT 2013 | JB
We are breaking a 1995 Dek 265GS screen printer for spares, it has the blue under screen cleaner, green 2D inspection camera. Was in full working order before getting a new Dek printer installed. The reason for replacing it was the air line pipes had
Electronics Forum | Thu Jul 01 09:53:12 EDT 2004 | randygray
This depends on the options that the machine is equiped w/ Green camera, Vacuum under stencil wipe, etc.. Price range for 1998 20-30K US Regards, rgray
Electronics Forum | Fri Oct 06 11:41:11 EDT 2006 | Bill
UP1500 was not a real MPM machine, so not relevant. UP1500 was an SMTech (UK) machine, different sofware, camera, etc.... than an MPM machine. AccuFlex is now real MPM.
Electronics Forum | Fri Feb 23 07:58:27 EST 2007 | realchunks
Does your camera / stopper move to a spot where it can catch the boad when the middle sensor is triggered? It sounds like you may have your board stop coordinates wrong. Check your X measurement to be sure.
