Electronics Forum | Mon Jul 15 09:03:44 EDT 2019 | dekhead
It uses the same BS position regardless of feed direction. In right feed, it passes Board under the camera and when (board @ stop) sensor detects board has passed, drops the BS and reverses conveyor direction. There is "Right Feed Delay" parameter to
Electronics Forum | Thu Oct 05 12:51:27 EDT 2006 | john_smith
cn, Currently we have a DEK265GSX a DEK Infinity and a MPM UP3000 printers and previously had MPM Accuflex,MPM UP1500 and MPM AP24s. No advice for the UP3030. We always had to work on all of the MPM printers for one thing or another and every time we
Electronics Forum | Tue May 22 09:11:35 EDT 2007 | jola
Hi. We have changed our produktion from high volume to medium/low and have to start hunting change-over time. We have a lot of products with two sides and the settings of pins in the DEK 265 and Fuji QP242 machines when running b-side takes to long t
Electronics Forum | Fri Aug 09 14:38:56 EDT 2002 | burb1999
Any one using/used a DEK ELA? I have used the DEK 265GSX so just wondering differences (sure I could look it all up but...) now if I had a choice what would I want a used 265GSX or new ELA? I believe the camera on the ELA is better than the GSX and
Electronics Forum | Mon Apr 11 08:47:34 EDT 2005 | Rob
There's not many ways of doing it on the cheap except... Buy a second hand universal GSM1 with VME 630 vision, 0.5 mil per pixel camera & some expensive ceramic nozzles for the 0201's. This will be quite slow & the software quite awkward but lookin
Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
Electronics Forum | Mon Feb 26 12:10:24 EST 2007 | JCB
As you are running Left to Right it is the trailing edge of the board leaving the board at left opto that tells the board stop to lower (not the sensor under the camera - that just confirms the board has arrived at the board stop). How big is the boa
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Fri Apr 29 22:35:01 EDT 2016 | dekhead
Pneumatic failure is a good guess, as GSX/LT are renowned for their leaky airlines. However on this I would doubt, since the Board stop is a single throw pneumatic with a spring to retract. The return spring broken / disconnected is certainly a possi
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN