Electronics Forum | Wed Dec 19 18:48:31 EST 2007 | darby
The other thing you could do is fit the cameras with a catseye lens. With my way all the data says the same apart from the fid diameter/shape and logic off/on. Just as accurate as any other method, a lot cheaper - cost = 1 drill, less nerve racking
Electronics Forum | Fri Sep 03 03:49:24 EDT 2010 | sachu_70
In case of pure pattern recognition, i agree with your view. However, the basic functionality of the fiducial is determine any positional offset of the PCB and provide necessary data for correction during the intended operation such as Paste printing
Electronics Forum | Fri Apr 01 18:32:51 EDT 2011 | frcdave
Dback, Some questions for you: 1. Are you using the red light configuration for better contrast on the 0402 parts? 2. Is your system fitted with both low and High Magnification cameras? Have you spoken with the guys at YESTech? Their phone support i
Electronics Forum | Tue Jun 12 20:54:34 EDT 2018 | dekhead
I don't recall a "Heavy Pallet Rails" option in software; I believe you need to change the Remote Board Stop to "Not Fitted" and move the pneumatic and electrical (BSK6)connections to correspond with the camera mounted board stop. Pretty well detaile
Electronics Forum | Wed Feb 02 20:14:56 EST 2022 | dwl
Make sure your pick up and Placement theta are correct. SOT-23 are notorious for having bad theta data in part libraries. I had an old placement machine that would center the part with an upward camera, looking at the feet. If I had the wrong pick t
Electronics Forum | Thu Feb 17 00:03:26 EST 2022 | sarason
Install one of those $20 readers on a spare Windows 95/98 PC, that fit in a 3 inch drive bay and then go for it. They can stuff up drive letters, so dont do this on a development machine. I used to use them back in the day of digital cameras. saras
Electronics Forum | Wed Feb 27 04:23:13 EST 2008 | fujillews
Hi It is best to fit the VGA camera for 0201 parts make sure your software is high enough..above v1.33 although you can place without but no so good. 0.4mm tapered nozzles are best. 0201 feeder the locator base in increased by aprox 0.3mm and the ind
Electronics Forum | Thu Aug 19 22:21:57 EDT 2010 | jeffr
If you need a disk, I can get it. You only need a sample USER.MCH file. You can use the sample disc to start both the 84V and 66V but after you must set the configuration of both machines as I do not know your options fitted. You will then need to Ca
Electronics Forum | Sun Mar 25 08:45:00 EDT 2018 | jacobidiego
Normally some random components of size 0604 or below and may be due to a thermal mass being close like a transformer or AC electrolytic caps. We tried changing fan speed, but this will change the thermal profile and avoid the thermal mass from bein
Electronics Forum | Sun Mar 04 02:39:27 EST 2012 | eadthem
I don't have our DEK printer part numbers memorized, In general we have a older machine running NT4.0 . It has 2Di inspection but we never use it because you can only inspect/setup 1 camera shot at once, making for very long programming. Our newer D
.png)
