Electronics Forum | Thu Apr 22 12:36:34 EDT 1999 | Steve Gregory
Hey ya'll! I just wanted to give you a picture of the washer baskets I made to show how simple they are to make (and I wanted to try out my new digital camera too). The picture shows a basket I made in about 15-minutes and with about $1.99 worth of
Electronics Forum | Tue Apr 28 23:48:20 EDT 1998 | Jojo
| I'd like to find a buyer for the following used equipment: | Make: Universal Instruments | Model: 4713D Adhesive Dispenser | Options: Rotatable dual-dot head (0deg, 90deg) | Price: Asking $4K (No reasonable offer refused) | I should note
Electronics Forum | Wed Jul 16 18:08:11 EDT 2003 | mgershenson
OK, disclaimer; I'm a salesguy, but I was a process engineer for quite a lot longer than I've been in sales. Your question is very vague, and may be difficult to answer. There are many ways to configure AOI to inspect solder, but as has been pointed
Electronics Forum | Fri Feb 06 15:52:18 EST 2004 | pjc
SPM is superior in terms of technology and application. SPM has larger print area, up to 20� x 19", vs. 17.7� x 15.7� for the MicroFlex. MicroFlex is microprocessor controlled while the SPM has a PC. SPM can print down to 12mil (0.3mm) fine pitch no
Electronics Forum | Wed Jun 02 16:33:08 EDT 2004 | davem
Fuji is the best, but there are other alternatives besides Quad. If you really want to look at Fuji, take a peek at their XP142E series. With "Vision processing on the fly" and a "Mini Turret Head" with 12 placement nozzles it should fit your needs n
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Thu Nov 29 00:38:57 EST 2012 | iqvisionmachine
About iQVision Incorporated in July 2011, iQVision’s mission is to provide reliable, robust vision-inspection solutions to Australian manufacturing industries, by establishing, then automating, objective quality processes. iQVision is a Matthews-af
Electronics Forum | Sat Jul 12 03:45:19 EDT 2014 | comatose
If you're getting quoted .045 seconds per chip, or .9 seconds per IC, one of two things is happening. The most likely is the supplier has two machines in the line, one placing small parts quickly, and one placing large parts slowly. The part will run
Electronics Forum | Tue Dec 12 17:34:39 EST 2017 | spoiltforchoice
A pattern emerges, but really I think it means plan/optimise for your day/week not a single job. Our machine uses 10's, this means there's a significant chunk of the feeder that is not easily accessible if something like a brass shim gets stuck or f
Electronics Forum | Wed Feb 13 08:15:05 EST 2019 | SMTA-Joe
We recently had an in-house demo with the smaller IR bottom heater PACE machine. The machine was barely able to remove some components, but could not replace new ones at all. Also, the nozzle for the hot air would not fit in the tight areas of the ho