Electronics Forum | Mon Sep 20 13:55:37 EDT 2010 | jamyboy
Check to make sure that the front and back of the DEK265GSX covers are closed. I have seen issues where the back cover trips its interlock and people go other places to look for the problem.....hope this helps
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Mon Sep 20 14:11:39 EDT 2010 | dman97
Yes I have checked both covers and they are both closed. The latch keys are sitting in their respective slots. I need to know how I can lower the hood manually or if there is a way to get into the diagnostics menu before the machine boots. Thanks.
Electronics Forum | Mon Sep 20 14:15:32 EDT 2010 | dekhead
"System Suspended While Cover is Opened" indicates front or rear cover opened; not the head being raised. Therefore there is an issue with one of the cover interlocks not being made properly. Note there are 2 switches on each (NO and NC) one goes int
Electronics Forum | Mon Sep 20 11:58:22 EDT 2010 | dman97
Hi, I was wondering if anybody knows of a way to close the hood on a 265gsx after it has been opened and the machine has been shut down? What I’m trying to say is that the machine was shut down with the hood raised and the prop rod on. When I boot
Electronics Forum | Mon Sep 20 13:05:05 EDT 2010 | dman97
Hi, Yes I tried to do that. When I stick a key inside the slot, I still get a system suspended error. Although I can press the system switch and I can hear the locks engage, but nothing happens. the machine still thinks the covers are opened and
Electronics Forum | Mon Sep 20 14:47:59 EDT 2010 | dman97
DEKHEAD, Thanks for the repies. I have checked and re checked both cover switches, and both are making contact. I have even stuck bypass keys into both slots and still i get nothing. When you say it is an IO error, how would I go about checking t
Electronics Forum | Mon Sep 20 18:25:57 EDT 2010 | dman97
Thanks for all the repiles. I finally got this machine up and running. Thanks again.
Electronics Forum | Tue Sep 21 15:16:10 EDT 2010 | dman97
I swapped card 3 and 5 in the Y2 enclosure. That seemed to fix it for now.
Electronics Forum | Tue Sep 21 15:27:01 EDT 2010 | dekhead
Assuming you mean the Y3 enclosure.
