Electronics Forum | Mon Oct 06 15:17:08 EDT 2008 | smellew
DEK 03 everytime, what printers do you use right now?
Electronics Forum | Thu Dec 22 16:59:39 EST 2022 | goseese
My problem was the BGE9010C. Any time there was any pressure on the rising table the error would occur. I was not able to find a replacement BGE9010C so I opened it up and found some blown components. Replaced them and the problem was solved. I "
Electronics Forum | Tue Mar 23 16:37:23 EDT 2010 | mmjm_1099
Hello all, I am currently looking for either the CMOS chip for one of the smaller pcb boards within this camera or a used graphite camera. Please email me mmartinjr@ymail.com
Electronics Forum | Tue Mar 08 15:52:00 EST 2016 | sarason
Dead sensor ? Try a little of your consumable directly on the sensor while monitoring it's output with a multimeter. sarason
Electronics Forum | Tue Mar 08 23:02:18 EST 2016 | dekhead
If it is a Vortex Cassette error, that is based on "Cassette Life" Programmed into Product file. Maybe erroneous software setting.
Electronics Forum | Sat Mar 04 16:56:13 EST 2017 | crecinos
A dispensing glue machine that you recommend? Currrently I am using a DEK 03iX for this operation, but cycle time is too slow, so I am looking for a glue dispensing machine, fast and with very good accuracy.
Electronics Forum | Mon Mar 06 15:58:10 EST 2017 | bk
Ok i must be missing something. You are using a dek 03i screen printer for glue and it's not fast enough? there is no glue dispensing machine that i know of that will ever be faster then a screen printer at doing glue dots
Electronics Forum | Fri Mar 25 06:20:13 EDT 2016 | buckcho
Hello, does it show which consumable it is? It looks simple - all consumables on Dek 03 require for them to tell them that you are replacing them in the proper menu, otherwise will give you error even if you replaced them. For example you can check a
Electronics Forum | Mon Mar 13 14:25:11 EDT 2017 | claytoneh
A dispensing glue machine that you > recommend? > > Currrently I am using a DEK 03iX > for this operation, but cycle time is too slow, > so I am looking for a glue dispensing machine, > fast and with very good accuracy. The fastest that I have
Electronics Forum | Sun Jan 16 16:51:23 EST 2022 | silverlead
Chapter 7 - Machine Control of the DEK manual outlines connectivity between the rising table servo node 6 and the NextMove ES card. If you don't have the manual, just PM me. I'm not an expert in DEK repair, but the solution could be as simple as clea
.gif)
