Electronics Forum | Sat Jun 24 15:31:40 EDT 2006 | mark
Hello, We have found that many times for DEK265GS in under stencil cleaning unit stucks cleaning paper (non-woven rolls). DEK said that cleaning unit for DEK265 has this problem. I just looking for improvment to eliminate issue. Question to the u
Electronics Forum | Thu Jan 30 07:29:15 EST 2020 | richardcargill
Finishing off tidying up/ cleaning a DEK 265 mk1 and inside ( front/centre ) are 4 silver pots and a pressure gauge. All the labelling is unreadable. I know the gauge is sort solvent dispensing, but no idea on what the pots adjust. Can anyone shed a
Electronics Forum | Wed May 24 15:40:08 EDT 2000 | A M
I work with a Dek 265 horizon, and i like the machine it`s very good. In this machine i work with Proflow, in the begine i have some problems but now it`s work very nice. It�s more expencive, but the stencil it�s more durable, the machine it`s more c
Electronics Forum | Mon Jul 03 22:40:58 EDT 2006 | eyryren
Dear mark This is Eyry Ren from Shenzhen comofaje Tech.co.,Ltd.We are the manufactucturer of SMT stencil clean rolls.If you have any problem please send mail to sales@comofaje.com. Our Engineer will give you a satisfying key
Electronics Forum | Fri Jun 04 09:31:48 EDT 2010 | thanh
there are 2 rail lift sensors at left and right of the table, maybe need to clean or re-adjust.
Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Tue Aug 16 06:20:34 EDT 2022 | bukas
it can be a bad contact with backboard. clean the slot and gold fingers with contact cleaner and push it in and out a few times.
Electronics Forum | Mon Jul 03 03:42:32 EDT 2006 | teera
hello, pls check below item for paper stucks: 1)paper rolls diameter not over 60MM(new roll) 2)tension for roller clutch(silver u.s.c only) 3)make sure the under screen cleaner ROUGH ROLLER is clean and free for solder paste.so that it can turn smoot
Electronics Forum | Tue Mar 20 05:03:47 EDT 2012 | sunyb123
Dear sir, i have face same problem of motor Communication fail Card0,Card1,I Clean Whole card properly, change the battery new one ,reprogrammed mint, but Card 2&Card3 loaded the mint programmed but not in card 0 & card 1, Please suggest what to d
Electronics Forum | Thu Oct 18 06:29:20 EDT 2001 | Yngwie
Dave, yes, your assumption is right, We only do washing after the second reflow. The timing from the post primary reflow to wash is no longer than 2 hour. The line config is as such : DEK265 � 3x MV2F- 1x MSF � BTU - AOI � DEK265 � 3x MV2F � 1x MSF-
