Electronics Forum | Sat Feb 25 11:23:58 EST 2006 | Curt
You may need to re-load the MINT files.
Electronics Forum | Sat Jun 24 15:31:40 EDT 2006 | mark
Hello, We have found that many times for DEK265GS in under stencil cleaning unit stucks cleaning paper (non-woven rolls). DEK said that cleaning unit for DEK265 has this problem. I just looking for improvment to eliminate issue. Question to the u
Electronics Forum | Thu Aug 16 07:46:50 EDT 2012 | omur
We have the following problem with our DEK265GS during start-up: Loading Program... Loading Language... Stack Overflow! Any help / pointers would be much appreciated. Omur...
Electronics Forum | Thu Nov 03 18:20:15 EST 2005 | JG
Dek 265 GS Problem: Machine abruptly turns off. It can be in the middle of a stroke or just sitting idle. After the machine turns off we have to let it sit for a few minutes (sometimes 20) in order for it to restart. Any suggestions? Thanks in adv
Electronics Forum | Sun Aug 26 15:09:18 EDT 2012 | aelektronik
Did you try running an AV scan on your files.
Electronics Forum | Fri Feb 24 20:05:31 EST 2006 | Robert
I had a problem to calibrate the vision of the DEK 265LT machine. After touch the calibration vision button a error message come up "Unable to load file CALIBRA.PR1" Does anyone know what fault could cause this? Do i need a calibration program? Doe
Electronics Forum | Sun May 02 11:41:04 EDT 2010 | bruceb
My DEK 265GSX will not boot in the mornings. When I check my power supplies 5 volts is measuring 1.6v. When I disconnect 5v I read 5.3v on the power supply. When I reconnect to the power supply the problem goes away. Has anyone seen this problem and
Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Thu Aug 02 16:47:37 EDT 2018 | erici
Thanks for all your help guys. The problem ended up with the parallel port where the hardware key(dongle) was attached. The cabling from the pc to the parallel port at the back of the machine was defective. Cheers
Electronics Forum | Sun May 02 14:37:06 EDT 2010 | dekhead
Something is surging on the 5V line tripping overcurrent on PSU2... If you've got autoflex on the machine the Y15 is th most likely culprit... I've also seen it with the Y2. www.dekhead.com
winsouce.jpg)
