Electronics Forum | Wed Sep 13 12:30:20 EDT 2006 | ianlg
Hi If you are looking for a good solid reliable printer you might like to compare the Dek 248 and 100MV's with the R29-V from Reprint in the UK. It has great software and vision system and is built on a new platform whereas the Dek 248 and 100MV/Mi
Electronics Forum | Sat Jan 15 16:33:13 EST 2011 | dilogic
Our DEK248 started to behave oddly - squeegee speed can't be controller anymore. It always moves with max.speeed or something close to that, regardless of the current settings. Also, the table sometimes shoots out with very high speed. I am suspectin
Electronics Forum | Fri Jun 08 15:26:17 EDT 2012 | aex
I am looking for a technician that can setup a Dek 248 in San Jose, CA sometime next week. It just needs to be set up, powered and have a quick demo of operation. Please contact me if you are able to provide this service or know someone who can. T
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Sun Oct 21 22:05:01 EDT 2018 | srini1904
Hello, We have Dek 248 Icon i2 semi auto screen printer. This machine was not in use for long time and Bios battery was dead. We replaced Bios battery and now date are correct. Issue is its not communicating to control board. Suspecting Bios setti
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Wed Sep 04 12:02:03 EDT 2019 | spinn
Hi all, Just to add further information to this post. We have 10 inch (250mm)and 19 inch (480mm) Dek 248 complete printer squeegee clamps with blades. On the 250mm one blade has a very slight kink though shouldnt cause a problem. Offers welcome
Electronics Forum | Tue Sep 05 17:38:27 EDT 2006 | flipit
I have a lot of experience on 1995 vintage Dek 248 and Dek 249. The 1995 to 1997 vintage were not the best. If Dek has improved them, great! If not, then I would not buy one. Dek 265 is a great printer. Dek did not put a lot of support into Dek
Electronics Forum | Mon Apr 19 14:24:50 EDT 2004 | Debi
i hope that this forum read people who have possibility work with Microflex and DEK 248 and i want to know their opinion. Debi
