Electronics Forum | Mon Feb 07 13:37:19 EST 2011 | dekhead
You don't say what generation of 248 we're working with... there are a few. Get in touch; I should be able to assist. http://www.dekhead.com
Electronics Forum | Thu Aug 09 23:18:15 EDT 2012 | dekhead
Depends on to what degree it has been disassembled; How much verification of repeatability is required; and if everything actually works... 2 hour - 2 days.
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Mon Jun 23 21:28:33 EDT 2014 | dekhead
Not something that pops up on used market much; but still available from DEK. P/N: 002070 I think ~$200 for a set of 4 DEKHEAD www.dekhead.com
Electronics Forum | Wed Oct 12 10:57:18 EDT 2016 | dekhead
Could certainly be sensors; does table (attempt to?) move out upon machine initialization? Or could be bridge driver (on board) or motor. JOHN www.dekhead.com
Electronics Forum | Fri Feb 16 05:39:56 EST 2018 | abo2016
we came across the following error this morning while working on the DEK 248 screen printer. Table in/out error message. Can we be assisted with fixing this please..
Electronics Forum | Wed Mar 21 19:35:38 EDT 2018 | dekhead
Not sure what blowing an airline would have to do with this; I sent you an email to get information on machine specifics for the procedures you need.
Electronics Forum | Thu Jun 27 10:51:59 EDT 2019 | key
Good news we fixed the unit. The air pressure for the RS was not off. made a small adjustment for the in and the out. unit working fine.
Electronics Forum | Thu Jul 18 13:15:25 EDT 2019 | dekhead
I guess you were able to locate the RS cylinder. Assuming adjustments to RS flow controls was your resolution.
Electronics Forum | Thu Feb 04 15:57:13 EST 2021 | dilogic
We had the same problem and it was caused by faulty encoder, which we had to replace. - Dejan
.jpg)
