Electronics Forum | Sat Feb 27 16:47:35 EST 2021 | petter
Looks like it was the diode inside the encoder. Are getting a new printer instead. Did a short time fix, connected a power supply to the motor and controlled the speed that way.
Electronics Forum | Sat Nov 06 06:41:11 EDT 2021 | ttheis
The DEK248 we had at one time was pretty compact but it did not have automated alignment- just a semi-manual camera/monitor stencil alignment process.
Electronics Forum | Mon Apr 18 09:52:36 EDT 2005 | pjc
FormFlex and the GridLok system will not work on a semi-automatic printer. They were designed for fully automatic machines. The print table is very shallow on the DEK 248, SMTechs and MPM SPM, UP100 and MicroFlex. DEK should have magnetic base suppor
Electronics Forum | Tue Mar 02 16:09:51 EST 2004 | Stefan
Hallo question to people who had experience with two screen printers: MPM new one Microflex and DEK 248. Which in your opinion is better for fine pitch application and meintance. Second qiestion does anyone knows something about KISTech screen print
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Sun Dec 20 12:42:57 EST 2015 | dilogic
We have DEK248 and Ultraprint100 printers. Ultraprint100 has custom video hardware while DEK has PC-based vision,which I prefer. Both perform roughly the same, and each has some design advantages over the other. We do routinely print 0.5mm pitch TQF
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Mon Jul 29 08:21:54 EDT 2002 | pjc
All DEK 248 semi-auto printers have been built in China for quite some time (years). Its shipped to the UK from China. All DEK ELA models are now built in China (past 6 mos.?). Thats the fact Jack. All MPM models are built in Mass. Its the savings in
Electronics Forum | Thu Mar 04 08:49:12 EST 2004 | ianlg
Hi Kistech is a UK based company. The MD is a David Wheatley who was one of the founders of SMTech Ltd who designed and manufactured the 100MV prior to the company being purchased by MPM. The microflex is a re-engineerd version of this machine. The