Electronics Forum | Tue Aug 23 16:57:29 EDT 2005 | HOSS
50% of seeing it in a single pass. The only time we do this is if we have a board off the line that has delaminated. We'll run a sample of boards through bare to confirm that we have a bad batch. Even if we see no failures on the bare boards, we'l
Electronics Forum | Mon Jun 13 09:43:11 EDT 2011 | mosborne1
Delamination almost always is caused by moisture in the PCB. You can try to keep some of the PCBs in a dry box after recieving them. You can also slowly heat them up to bake out moisture. If you are purchasing boards form overseas form a board house
Electronics Forum | Sat May 09 09:00:54 EDT 2009 | davef
For more on using tin as a resist during bare board fabrication, read "2.5.6 Introduction To Tin And Tin/Lead Plating" here: http://books.google.com/books?id=etfNcpiR5ZUC&pg=PT570&lpg=PT570&dq=%22circuit+board%22+%22etch+resist%22+%22acid+sulfate%22&
Electronics Forum | Mon Mar 12 08:00:14 EDT 2007 | rgduval
It sounds like you may be thinking of two different test methodologies. What is required? Bare-bard testing, to verify pcb fabrication? Or populated board testing, to verify manufacturing? If it's bare board testing, the fab house should advise a
Electronics Forum | Sat Mar 17 04:50:58 EDT 2007 | tanemmirt
thanks davef, your help was really segnificant.
Electronics Forum | Thu Jun 17 17:26:56 EDT 1999 | wayne sanita
first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads. any
Electronics Forum | Tue Mar 13 21:28:16 EDT 2007 | davef
Try this: http://www.accutroninc.com/download/ict.pdf We have no relationship, nor receive benefit from the company referenced above.
Electronics Forum | Fri Jun 18 17:47:09 EDT 1999 | Scott Cook
| | Carson Valley Inn be hanged, | | | | Moonman | | | Carson Valley Inn, Wow they should have a plague there that says, "Mike Cox once Stayed here", Good Ol days | Mike, until 4 years ago when I built my current home and moved, I was STILL rece
Electronics Forum | Fri Jun 18 10:24:12 EDT 1999 | John Thorup
| first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads. an
Electronics Forum | Mon Mar 12 03:41:25 EDT 2007 | tanemmirt
i designed a new product; i want to produce it in china, so they requested the ICT to be done; i have 03 questions if some one can help me on: 1� is it mondatory to test all components and paths in the PCBA; and check all soldering joints? 2� testing
.gif)
