Electronics Forum | Tue Jan 05 18:07:53 EST 1999 | Dave F
| I am looking for information regarding post wave soldering of stranded wires into a circuit board using OA core wire solder. We do a final pass thru the cleaner after the hand soldering but I'm concerned about any OA flux residue that may have wic
Electronics Forum | Thu May 26 16:41:00 EDT 2011 | scottp
Here's what I do: - Test Surface Insulation Resistance (we're in the high reliability market and use a test significantly harder than IPC's). I also test SIR in combination with other assembly materials like conformal coatings and wave solder flux
Electronics Forum | Mon May 10 08:00:14 EDT 1999 | Timothy O'Neill
| | | | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so
Electronics Forum | Tue May 04 14:42:58 EDT 1999 | Chrys Shea
| | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I wi
Electronics Forum | Mon May 10 07:53:48 EDT 1999 | Timothy O'Neill
| | | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I
Electronics Forum | Tue May 23 02:41:37 EDT 2017 | zsoden
Thanks Bukas. I've actually gone to a lot of trouble over the past 24 months to completely clean, rebuild and adjust the pump and nozzle assemblies and even through all of that we've still never been able to get theoretical maximal wave height from t
Electronics Forum | Sun May 21 23:29:38 EDT 2017 | zsoden
Hi all, We run an old Seho 1135C wave solder with a 63/37 pot at 250°C. It has been running well for a couple of years but we have noticed lately that all of the larger pads (terminal blocks, transformers, etc.) require additional solder to be appli
Electronics Forum | Thu Aug 03 17:53:58 EDT 2017 | zsoden
That may just be an optical illusion. I've just measured and they're cut to just over 4mm (0.157"). The pot is at the level specified by the manufacturer (5mm from the bottom of the PCB if I remember correctly).
Electronics Forum | Thu Oct 23 09:49:18 EDT 2008 | davef
We're not sure the specifics that BLT Circuit Services Ltd referenced, but many companies use dross reducing agents in their wave solder pots. Among dross reducing agent suppliers: * Fry [4100 Sixth Ave, Altoona, PA 16602; 814-946-1611 F814-944-8094
Electronics Forum | Wed Nov 17 11:20:23 EST 1999 | Dave F
Hey Gyver: If you don�t mind (which you don�t have any choice about, because I�m going to do it anyhow, cause it�s MY word processor), I�m going to respond genericly, but still be directed to your question. Much of the following is paraphrased from
