Electronics Forum | Mon Jun 05 03:06:24 EDT 2017 | mun4o
hi, are you resolve the problem? I have the same solder wave and the same problem. Can you advise my something? Regards
Electronics Forum | Thu Nov 20 18:57:52 EST 2014 | warwolf
I can only say it looks okay for what you need, you will want a dual wave system it can make things so much easier. One thing to check would be the wave nozzle sizes I can see that the conveyor will do up to 15" but thats not to say the nozzle is
Electronics Forum | Wed Oct 12 08:34:48 EDT 2016 | assuredtech
Speaking from experience, the solder pot surface has become "wetted" so to speak, so solder will naturally wick and seek. Allow the level to go low (perhaps 1 inch plus), clean the top surface area of the solder pot as best as you can - try to remove
Electronics Forum | Sat Oct 08 04:24:37 EDT 2016 | aaronpainter
We are having an issue with the solder bars hanging the solder feeder dripping down the back side of the pot, and leaking in to the area where the terminal block for the elements on the pot are. We have tried aluminum tape to close off the gap betwee
Electronics Forum | Thu Nov 20 14:49:54 EST 2014 | joe98375
Greetings, I am looking into buying a wave solder machine for medium production of 100% through hole boards (~8.5"X12" dimension, not many layers, no high density part areas,
Electronics Forum | Tue May 17 10:11:54 EDT 2005 | russ
I would use a foam fluxer since spraying rosin will make the stickiest nastiest mess you can imagine. 18 layer board huh? You will want convection preheat, both top and bottom preheaters, preheat tunnel of at least 4-5', a chip wave, laminar flow w
Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 20:35:51 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
Electronics Forum | Thu Jun 17 15:18:54 EDT 1999 | Earl Moon
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Thu Jun 17 19:52:57 EDT 1999 | Tony
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w