Electronics Forum | Thu Oct 22 12:30:33 EDT 2020 | emeto
So is the initial motor at fault failing now or the one from zone 3?
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Fri Oct 05 15:37:07 EDT 2012 | mili
another delta wave have the same fault, same symptoms!!!
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg
Electronics Forum | Fri Sep 14 10:53:25 EDT 2012 | mili
In Setup menu there is a last option Debug. Debug choosing a window with Rack0, Rack1, Rack2, Rack3, log RS485 opens. Choosing rack0 a window with parameters S3 boxes 1 to 12 Input and certain boxes are checked, S4 Output from 1-8, from 1-8 S5 Outpu
Electronics Forum | Fri Sep 14 08:53:43 EDT 2012 | mbnetto
Hi, Recently we acquired a Delta 3 and I noticed everytime we change any value regarding to the tracking system, as chip or main wave - offtime/ontime- with boards loaded on it, the tracking system doesnt work well. sometimes it turns off the wave o
Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden
We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa
Electronics Forum | Wed Feb 06 02:14:43 EST 2008 | mun4o
Hi, we use Vitronics Delta 6622 solder wave.I try to adjust high of backplate, but I don't know whether the adjustment is correctly.Now, when the frame enter in the main wave, solder flow in the same direction as PCB.But when the frame go above main
Electronics Forum | Thu Oct 25 11:29:04 EDT 2007 | ck_the_flip
Forget all the bickering and semantics. EVERYONE IS RIGHT!! ...but then again, in soldering, there IS no right, wrong, or indifferent... just blame. :-) Soldering is, after all, the most difficult process with the most opportunities for defects.
Electronics Forum | Thu Feb 14 04:40:38 EST 2008 | lococost
You want the backplate set up so that when there's no PCB the wave stands still or moves towards the PCB. When the PCB moves over the wave, it should just pull the wave towards the back (in the same direction as the PCB). This will help reduce brid
