Electronics Forum | Wed Feb 06 02:14:43 EST 2008 | mun4o
Hi, we use Vitronics Delta 6622 solder wave.I try to adjust high of backplate, but I don't know whether the adjustment is correctly.Now, when the frame enter in the main wave, solder flow in the same direction as PCB.But when the frame go above main
Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden
We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa
Electronics Forum | Tue Sep 17 13:58:56 EDT 2013 | smtventasmex
i have a vitronics Delta 6622CC with a software fail, i turn it on and when i open the software on the CPU, it enter but show me a message of wrong vertion, and then i choose ok and software close it self, let me know if some one of you have this fai
Electronics Forum | Mon Oct 19 05:16:56 EDT 2015 | florintoma
Hello all, I have a problem with the wave 6622c . The temperature of solder pot and preaheating zones 1 and 2 is not increasing. the strange thing is that the machine is not display no error. Can you help me with some advices?? regards
Electronics Forum | Sat Oct 08 04:24:37 EDT 2016 | aaronpainter
We are having an issue with the solder bars hanging the solder feeder dripping down the back side of the pot, and leaking in to the area where the terminal block for the elements on the pot are. We have tried aluminum tape to close off the gap betwee
Electronics Forum | Mon Dec 17 02:08:21 EST 2007 | mun4o
Hi, I have a lot of solder bridge in our wave soldering process.We use SACX0307 and Surf 11 flux.the SW mashine is Vitronics delta 6622.Itry to change flux and termoprofile but results is not god.Can you halp me - recommend me some flux or other adv
Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Mon Oct 19 09:59:30 EDT 2015 | cbeneat
I've never had that particular problem with our machine, but I do know that if the CB pop for whatever reason the machine doesn't give an error. So I would check those, if you haven't yet. Also under options you can do an element check, see if that
Electronics Forum | Thu May 28 01:48:16 EDT 1998 | Roni Haviv
Hello, I need some users information about "hot air knife" after the wave bath: - Defects reduction ? - In what kind of boards(TH/SMT SOICS ect.) it is applied ? - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ?
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
