Electronics Forum | Wed Mar 17 10:12:16 EDT 2010 | dj_jago
Is it the pressurized system or the pump system you have fitted to the machine? Are you getting an error message 'No flow nozzle 1'? Check the 'ShoRate' gauge at the back of the machine and make sure the ball bearing rises in the glass tube when you
Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili
Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg
Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden
We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Thu Sep 06 17:37:05 EDT 2007 | hakerem
Hi Joris - There is an excellent wave solder guide called "Take No Prisoners" that includes instructions for attacking and eliminating solder balls and preventing their recurrence: 1. Increase Dwell Time Solder balls are normally caused by too much f
Electronics Forum | Mon Apr 09 09:39:40 EDT 2018 | justconmac
Having an issue with tracking for the Vitronics Soltec Delta 3. Wave will not give error on "expected PCB at exit" but will still show 1+ pcb's in the wave when the machine is empty. This is causing solder pump to idle unnecessarily. Outfeed sensor i
Electronics Forum | Thu Sep 02 10:41:41 EDT 2004 | dj_jago
Other way around Dave. We decided that the Delta had more in common with the Electra rather than the Vectra, the Electra being much more expensive. For example, we wanted 3 preheat zones for lead free and this would mean an exernal fluxer unit if
Electronics Forum | Fri Sep 17 02:12:16 EDT 2004 | Adam
Rob The machine is SEHO MWS8240, Fitted with a foam fluxer, a combination of IR,Quartz and Convection preheaters together with a chip and delta wave. Adam
Electronics Forum | Wed Mar 16 17:34:20 EST 2005 | pmd
decrease pump rpm, for penitration try tweeking pitch as well as belt speed. On the delta wave spray pitch and belt speed are related.
.gif)
