Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden
We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa
Electronics Forum | Tue Oct 11 14:02:59 EDT 2016 | mnorthey
We have a slider Bar on the back side of our Delta Wave. It is adjustable and slides up and down (adjusting bolt) on the back edge of the Lamda Wave to prevent this problem; keeping the trough behind the Lamda is essential as well. Along with attenti
Electronics Forum | Sat Oct 08 04:24:37 EDT 2016 | aaronpainter
We are having an issue with the solder bars hanging the solder feeder dripping down the back side of the pot, and leaking in to the area where the terminal block for the elements on the pot are. We have tried aluminum tape to close off the gap betwee
Electronics Forum | Wed Aug 09 09:25:57 EDT 2006 | Mike F
Am I missing something here? I usually put some type of stiffener or support on the leading edge to make sure the PWB doesn't sag in the middle from the preheat. If I had to add a bean bag with shotgun pellets or BB's I would have boards falling out
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Mon Jun 29 07:17:25 EDT 2015 | donlockard
Seho maxi wave 3240 should be considered as well. Invented full tunnel nitrogen systems that have lower operating costs and provide yields unlike what can be achieved by air wave systems.
Electronics Forum | Tue Nov 09 23:52:31 EST 1999 | chartrain
Could very well be your nitrogen diffusers are blocked. These have to be cleaned on a regular basis as well.Cleaning frequency for the diffusers is flux dependent as well as other factors but could be as little as one month of operation. Once the dif
Electronics Forum | Mon Apr 09 14:51:04 EDT 2018 | justconmac
UPDATE The reason for the board count in the wave when there are no boards is due to operators leaving racks with empty PCB slots. The input feed sensor is a little bit more in the center of the conveyor whereas the output feed is a slightly closer t
Electronics Forum | Sun May 21 23:29:38 EDT 2017 | zsoden
Hi all, We run an old Seho 1135C wave solder with a 63/37 pot at 250°C. It has been running well for a couple of years but we have noticed lately that all of the larger pads (terminal blocks, transformers, etc.) require additional solder to be appli
Electronics Forum | Wed Feb 15 19:20:46 EST 2006 | Mr. Samir
Russ, On both instruments, I ran them through the wave 20 times each using identical profiles and wave parameters, and then used statistical formulas to measure the variation and repeatability of each. I had these all in Excel, but that was around 1
