Electronics Forum | Fri May 26 10:01:53 EDT 2006 | Chunks
I hope so, my reply wasn't that funny. Although my new process of boards that grow their own parts by exposing them to B.S. has been so successful that we no longer need breakaways. They all totally green since they are organinc as well! P.S. Moo
Electronics Forum | Fri May 26 14:24:30 EDT 2006 | Chunks
Thanks Pete, I wish every video for each piece of I bought went as smooth right after recieving it. That's why I always try and ask current users about things to avoid or options to buy. I'm sure their sales guy will tell me everything (add joke
Electronics Forum | Tue Jan 30 09:31:08 EST 2007 | russ
these assemblies getting depaneled? ICT? any fixtures or anything? I would check your print and placement equipment and make sure there are no support issues as well. But I believe you mentioned fractures so that would be happening after the reflow
Electronics Forum | Sat May 16 13:14:07 EDT 2009 | pioneerdietecs
Pioneer-Dietecs Corporation makes depaneling dies and singulating presses. We make dies that can be used in a Wand press too. Visit http://www.pioneerdietecs.com for more information. Or send an email to larson@pioneerdietecs.com with a CAD file or p
Electronics Forum | Fri May 15 19:20:47 EDT 2009 | jlawson
if you have a budget for new machine, laser depanelising is pretty good for flex PCB as no physical stress on PCB like mechanical routing, thus fixturing is easier and less prone to moving the flex while cutting. Laser systens can also cut FR4 standa
Electronics Forum | Thu Jan 05 10:36:46 EST 2012 | davef
Singulation is much faster and cleaner than routing Here's a link to a fairly recent article on gang sawing CSP http://www.electroiq.com/articles/ap/print/volume-9/issue-10/features/step-by-step/step-11-the-back-end-process-singulation-step-by-step.
Electronics Forum | Wed Aug 22 12:48:47 EDT 2012 | tpatrickwalsh
They are using the method where scored boards are separated using a rotating wheel / blade. I realize this is not the best process, however these capacitors are more than 10 mm from the edge of the board. From some reading online I think that means
Electronics Forum | Tue Apr 08 22:55:01 EDT 2014 | padawanlinuxero
Hola Beto Here we use this one CAB MAESTRO 3E it's ok does the job well and both blades can take a beating before need to change them. http://www.cab.de/en/electronics/pcb-separators/maestro-3e/ Saludos Beto
Electronics Forum | Fri Jun 06 17:47:14 EDT 2014 | hegemon
SWAG has it. Carriers for SMT are a great idea, especially to mitigate sag, and allow some savings in setup. Fixturing setup advantage: You could fixture everything to a fixed width, and eliminate rail setups throughout your lines. Trade off the f
Electronics Forum | Thu Jun 12 12:35:52 EDT 2014 | clydestrum
I didn't even think of running a blade down those scores. I will give it a shot and see. The laminate they're using is Nanya NP-140, if anyone has ever used it or has any info regarding it's issues around something like this. We can see resin weave
Depanelizer Equipment and Tools For Electronic Assembly. PCB Racks and Trays. Wire Crimp Press and Tooling.
115 Pleasant Street
Millis, USA
Phone: 508 376 2500