Electronics Forum | Mon Dec 16 18:48:15 EST 2002 | rmejia
I need a good depanelization machine for mouse bites that is fully automated
Electronics Forum | Thu Nov 03 10:46:48 EDT 2022 | dontfeedphils
You can get a router with a saw blade to handle v-score, but if you plan on doing automated depanel/routing I would probably update my panels to mouse-bites and go with a standard bit based router.
Electronics Forum | Wed Oct 26 14:37:02 EDT 2022 | emeto
These pneumatic ones have always been around for mouse bites.
Electronics Forum | Wed Jul 26 10:42:43 EDT 2017 | proceng1
We have an array of boards that are difficult to depanel due to components being close to the edge. I want to route a space between strips (boards are 14" long x 1" wide) and have breakaway tabs like mouse bites, but the customer won't accept the ja
Electronics Forum | Thu Apr 14 14:16:22 EDT 2016 | joelperez
Has anyone use both methods of depaneling on PCB breaktabs? meaning v-score at the edge of the pcb and mouse bites on the opposite side of the tab (break out panel)? Thanks
Electronics Forum | Wed Dec 29 12:21:08 EST 1999 | Mike McMonagle
If you go with tabs/mouse bites, both FKN and Cab make simple pneumatic shears for removing the tabs. For low to moderate volumes, they're very cost effective. MikeMcM
Electronics Forum | Mon Jul 31 14:03:50 EDT 2017 | rgduval
Could always get a laser cutter to de-panelize with. I've always wanted one, personally...but, haven't been able to cost justify it. ..rob
Electronics Forum | Wed Nov 13 15:00:57 EST 2019 | stephendo
I have seen resistors cracked during placement. The part was programmed incorrectly and the nozzle pushed down on the part too hard. I do not remember seeing any cracked during depanelization. Nibblers can cause damage if they are on the bottom and
Electronics Forum | Thu Aug 22 22:10:26 EDT 2002 | davef
Ooooow! �Can it be fixed?� Good question. How BAD did you damage it? * Since you are asking this question, I am NOT inspired by the potential that you have the skills to fix the board. Go Jeff Ferry�s site at Circuit Repair Center [If you can�t f
Electronics Forum | Thu Jul 27 10:57:35 EDT 2017 | fkn
We make pcb depaneling equipment and many of our customers do a combination of tab routed panels with pre-score in order to speed up the singulation process. If you like, I can send you a picture of an example. Regards Klaus Heimann FKN Systek Tel.
