.gif)
Electronics Forum | Tue Jan 22 07:16:27 EST 2008 | aj
Hi all, Can anyone give me contact details of some Toolshops who can design & manufacture Wave Solder pallets in the UK ? aj...
Electronics Forum | Fri Jan 25 08:03:49 EST 2008 | bentigano
You could always open the .bmp in Paint, and then do a "Save as..." and choose .jpg as the file type. Everyone has Paint. Unless of course you're using a Mac, but then you'd probably be a graphic designer anyways...
Electronics Forum | Sat Jan 26 19:16:30 EST 2008 | mika
Can you have the designer to make a fixed area for this barcode? Meaning that you must have a position for this at the very same spot, unless your barcode system can be programmed to do barcode scanning on different spots, for different products/boar
Electronics Forum | Tue Jan 29 14:22:27 EST 2008 | operator
Yeah i don't know I have not seen the actual application. RTV was already discussed by the customer and they don't want it. That is what I was thinking too. It is poor design and they are trying to find a cheap way out that doesn't look cheap. Thanks
Electronics Forum | Mon Feb 18 17:55:33 EST 2008 | gregp
The Contact C5 is designed for your needs. I can supply references if need be. Go to http://www.contactsystems.com for more details.
Electronics Forum | Thu Feb 14 11:51:28 EST 2008 | sliebl
What Steve posted is what I was picturing. I think that the stencil would certainly not be as strong due to the surrounding apertures, but stencils can be replaced. Hopefully the assembly volume will allow for replacements as necessary due to the pec
Electronics Forum | Thu Feb 14 12:00:58 EST 2008 | aj
take a look at what solder preforms are available. You can get ones that can be machine placed. This might allow you to add paste to areas that you cant open up around the perimeter. aj...
Electronics Forum | Thu Feb 14 12:44:48 EST 2008 | operator
Don't worry about the paste print. Just omit it from the stencil. Mask over all the SMT components after reflow with water washable WSOL masking. Then run it thru the wave to deposit the solder. Then wash to remove masking. Or you could manually run
Electronics Forum | Thu Feb 14 21:24:20 EST 2008 | daxman
Thanks for the ideas! We're gonna try em all, I'll let you know how it turns out.
Electronics Forum | Mon Feb 18 17:36:32 EST 2008 | kennyg
I should have mentioned... the only flux we use for the hand soldering is wire-core, no bottle flux. I think it should be a non-issue to leave the activated wire core flux residue. I'm just looking for some way to prove it to the designer.
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
