Electronics Forum | Mon Aug 31 19:15:36 EDT 2020 | dilogic
We have GSM2 with FlexJet heads (an older one). There are 7 sensor amplifiers (with LED indicators) for touchdown detection and one for z-safe detection which is of a different type (with numeric LED indicator). I can't find anywhere what the right n
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki
Electronics Forum | Fri Feb 29 09:15:23 EST 2008 | jdengler
I do not know the QSV-1, but it sounds like there is a sensor that would detect when the clamp is open. Try to find this sensor and see if it is working.
Electronics Forum | Tue Aug 09 17:01:59 EDT 2005 | dougt
Is there a need for a professional conveyor swapper? Could I start my own business and make enough money doing something like this? I haven't worked on this conveyor but I'm sure I could figure it out. As it was said previous it's probably only a c
Electronics Forum | Wed Feb 14 16:44:01 EST 2018 | cbart
Probably to late for ya, but: -Center support -mesh belt and conveyor (have the mesh is nice for 1st side runs to keep the board flat. -N2 capable, in case you need it -on board profiling -smema if needed -board drop detect (sensor at input and exit)
Electronics Forum | Thu Apr 28 00:19:52 EDT 2016 | ttheis
I'm not personally familiar with the 265 but it sounds like the machine's board stop actuator is not retracting or a sensor that detects that actuator position is stuck (probably a reed switch.) If your stop is not retracted, then the sensor is telli
Electronics Forum | Mon Sep 16 18:45:26 EDT 2013 | mbb
Hello, We have currently Pick and place machine (Panasonic) with tape splicing joint sensor,the issue is, that once we want to change tape splicing for costs reason, the sensors don't detect any tape splicing .Is there anyone from Panasonic to expl
Electronics Forum | Thu Feb 22 19:37:48 EST 2007 | vshan
Hi All im facing an issue with my DEK. Once the middle sensor detects the board, the stopper does not able to stop the board on time. i have checked all the basic parameters. Can anyone help me rgd vshan
Electronics Forum | Thu Aug 15 03:23:05 EDT 2019 | sssamw
It depends your product application and requirement. If high level, 100ppm required, or even 2000ppm is also ok. There should have sensor detecting O2 ppm inside reflow.
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
