Electronics Forum | Thu Dec 06 11:01:19 EST 2001 | Carol Stirling
This SMT process certainly makes a body want to win the $$$ and retire! We have been trying to stabalize the process and keep running into new problems. Any help would be appreciated on this issue. All pads on both sides have the same look - partial
Electronics Forum | Thu Mar 05 11:53:09 EST 2009 | dcell_1t
Hello to all. for certain time, we have been struggling with some issues on a PCB where have tombstoning on 0402 components (due to pad design) and dewetting in qfp256 0.5 mil pitch (discussed on another threads on this forum) component, we have pro
Electronics Forum | Thu Mar 12 06:37:48 EDT 2009 | gregoryyork
I agree you are too cold for the profile get it up to 230C and possibly allow it to dwell a little longer in preheat as opposed to pushing up the reflow zone only. Sn90/Pb10 melts at 220C so 2C hotter than your profile so you are reliant on it alloyi
Electronics Forum | Fri Mar 06 10:46:35 EST 2009 | davef
First, we agree with Loco that your QFP is nonwetting, rather than dewetting. Your sceen-shots look like ol' timey SnPb paste recipes. Turn-up the heaterometer dial. Second, on nitrogen: * We kinda think your O2 needs to be around 100ppm with 99.99%
Electronics Forum | Wed Nov 06 10:03:59 EST 2013 | rgduval
Hi, Peter, I'm not an authority on surface finish thickness, and it's effect on reflowing, so, I can't advise on that front. If the boards are a week old, and ENIG, I would not suspect surface contamination. It's always a consideration, of course,
Electronics Forum | Wed Apr 18 04:22:43 EDT 2007 | ray
I facing dewetting problem on Ag/Pd termination(chip component)during reflow process. The solder wetting is pull to terminal side and exhibits dewetting. Any one ever face the same problem and any solutions for the problem?
Electronics Forum | Thu Oct 30 21:55:13 EDT 2014 | davef
Why soldering issues? I'd guess the nickel is corroded. It is very difficult to solder to oxidized nickel. Your SAC305 would get kicked all the way down the conveyor by nickel oxide. A lack of Ni-Sn-IMC formation will confirm this dewetting . What's
Electronics Forum | Tue Jun 07 08:57:14 EDT 2005 | ktron
Hi there, I have questions regarding on dewetting issue.. Q1) How to identify on good or bad ICs lead that could contribute to dewetting? Q2) What actions that must be taken in facing this issue? Thank n regards,
Electronics Forum | Fri Jun 03 07:28:14 EDT 2011 | denz34
Hi there, I have questions regarding on SMT RF Shield dewetting & misalignment issue.. Q1) How to identify on good or bad RF shield that could contribute to dewetting? Q2) What counter measure that must be taken when facing dewetting issue? Q3) W
Electronics Forum | Thu May 20 07:52:36 EDT 2010 | rgduval
In general, cleaning with deionized water is acceptable for most component. Open switches and contacts, in general, do not get damaged in this process. A good drying is required, of course, after washing. However, you've described dewetting issues
