Electronics Forum | Fri Feb 01 09:02:06 EST 2019 | dfl
dfl1973gamer@gmail.com yes, "2" it's working good, thanks for the tip
Electronics Forum | Fri Oct 05 07:22:28 EDT 2018 | dfl
Hi, I just got a Quad IV-c and I'm learning to use it, I got manuals and it is up and running on DOS with windows 3.1 but I noticed that it the Autoprogram is missing, Does anybody has a copy that can share. Regards
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Tue Oct 09 10:29:47 EDT 2018 | dfl
Thanks Bob. Using a flashlight helps a lot, indeed. Is "re-adjust the angle" just a bend on the LEDs heads (by hand)? I will try. To replace de LEDs, can I use white ones? I believe with the reds I get less light than whites, but maybe the camera ne
Electronics Forum | Tue Oct 09 11:17:24 EDT 2018 | dfl
Ok, I will try and post the result. thanks for the help!
Electronics Forum | Fri Jan 25 08:54:33 EST 2019 | dfl
For the first time, I'm really looking at to the power transformer for the IV-C pick and place (the big big one, at the middle). As I understood, is this transformer converting the 220V to 127V? I realize that the camera monitor is 127V and the PC PS
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Mon Jan 28 07:06:26 EST 2019 | dfl
Yes, the left to right movement. The belt looks tight. I will check for loose steps, thanks for the tip. I can't find a mod code for overall speed setting. Do you remember the number?
Electronics Forum | Wed Jan 30 15:08:10 EST 2019 | dfl
MM, exchange the cards doesn't make any difference. The problem happens when the machine is moving from left to right. Right to left works all the time. bobpan, thanks, I completely missed this one. The default was 0 and now is set to 1. The build c
Electronics Forum | Fri Feb 01 07:07:01 EST 2019 | dfl
Another semi-related question: are the four motion cards the same? (except for the dips, I guess). I have a spare one, marked as T motion, all dips to up position. Can I use as X or Y, if I match the dips? The boards look like to have the same comp
winsouce.jpg)