Electronics Forum | Fri Sep 22 11:51:32 EDT 2006 | chris g
Have you tried doing a short diagnostic test? That will check the repeatability and backlash of the axis. Did you use the C-tool when calibrating the camera?
Electronics Forum | Fri Mar 26 06:58:06 EDT 2010 | ristikas
Hello, We have here very oftenly one error in our MPM Accuflex. I dont know who to ask about that errors... The error is „The transfer light peam interlock has been broken. Remove the obstacle from the path of the beam.“ I checked the sensors and
Electronics Forum | Fri May 14 09:34:18 EDT 2010 | lockj69w
This procedure is from UIC's knowledge base. TO run Diagnostics on AISI 3500 vision. Use of this procedure will require reloading of vision executive once complete. 1. verify PC1 COMM2 is connected to COMM2 on the RADISYS board in slot 1 of VME chass
Electronics Forum | Mon Aug 19 23:25:52 EDT 2019 | rob1
We have a Yamaha GEM and the laser will not recognise components. The laser has been changed in the past by another engineer, but this failed to rectify the problem. Can anyone advise how to test the laser or use some machine diagnostics so that I
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Fri Apr 28 16:03:31 EDT 2017 | ilavu
I have GSM1 (OS/2) machine and it does not zero. The Y axis comes to all the way front to hard stop. I replaced the limit switch before the hard stop and can not find any way to test the signal from limit switch in diagnostic. I like to replace the c
Electronics Forum | Wed Mar 03 14:16:59 EST 2010 | davef
First, we expect that your equipment supplier would help you with this. Then again with lots of used equipment flying around, some of the basic stuff often gets pushed to the back of the bus. Second, here is a clip and paste on the basics of equipm
Electronics Forum | Mon Jan 06 19:12:52 EST 2020 | dekhead
If you are unable to get to Diagnostics to exit to DOS; Try the following: ‘F5’ (WHILE STARTING MS-DOS) –OR ‘CTRL’ – ‘C’ (WHILE HIMEM IS TESTING EXTENDED MEMORY) Once in DOS, CDMINT Type LOAD to download MINTS from HDD to cards. DEKHEAD
Electronics Forum | Thu Mar 25 12:24:12 EDT 2010 | ssager
When testing components on a PCBA, try to validate coverage for presence, correct, orientation, live, and alignment. AOI is not really great at catching cold solder joints and damaged components, and from my experience an X-Ray is only as good as the
Electronics Forum | Thu Jul 05 10:55:45 EDT 2007 | vickt
Daniel, What exactely are you trying to accomplish with this? Do you have a particular communications issue that requires this as a diagnostics tool? If so, there are lots of previous threads on this subject. Have you already referenced the IPC spec
.gif)
