Electronics Forum | Mon Sep 23 12:27:47 EDT 2002 | dragonslayr
Genny - are you still out there? I'm just a bit curious how your progress has been since your original question was posted weeks ago. It appears you have received a wealth of information. It also is evident that your posting has taken on a new tange
Electronics Forum | Tue Oct 24 19:09:12 EDT 2023 | sarason
Possibly blocked air lines did you check air pressure? Also drivers on the relevant boards. or simply damage in the flexible wiring harness( a nightmare) sarason
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Nov 06 12:06:04 EST 2007 | jdumont
Agreed, if your process is the same than most likely you received in a batch of lead free BGAs that are supposed to be leaded. Happens to us all the time and vice versa...
Electronics Forum | Thu Feb 14 23:32:50 EST 2013 | padawanlinuxero
Hello ! I don't know if this helps but here goes, I have here 2 mydatas one a TP9-4 and the other MY12, on the TP9-4 we have TPSys 2.4 and we use a AM8 feeder magazine, when we bought the MY12 it came with TPSys 2.1, thinking we can use the AM8 feede
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Fri Sep 23 09:18:48 EDT 2011 | oswaldorey
Same happenend to me with another flux some years ago, to me its a reduced viscosity of the flux, what I did was to reduce the width of the slot on top, where the flux exits, reduced the distance from stone to pcb and filled the flux reservoir to the
Electronics Forum | Wed Aug 29 12:12:14 EDT 2018 | solderingpro
What type of flux are you using today? - Obviously you have already outlined the difference in the parent materials and parent material preparation, so using the same program/profile will not work; the characteristics are different. Try increasing p
Electronics Forum | Sun Sep 28 17:14:53 EDT 2008 | ronsou
small pads like 0402 tend to get hot quite > easily. looks like excessive heat is your problem > here. pads are wetted, component leads are not. > this means solder paste flux on top layer was > exhausted before entering in reflow. your profile
Electronics Forum | Wed Jul 11 14:48:25 EDT 2007 | rgduval
My boss just received some info through a design mailing list that he's on claiming that FR406 is not RoHS compliant based on the limited number of processing cycles at RoHS compliant temperatures. I would guess that this is related to the relativel
