Electronics Forum | Wed Apr 02 23:02:38 EST 2003 | scottf
I agree with Iman. Verify the integrity of the component for moisture. Most definately place an amount of ownership on your PCB supplier. Request tank analysis results and copies of the lot travelers. Look specifically for any in process rework pro
Electronics Forum | Tue Apr 01 11:50:08 EST 2003 | rdr
Dave, thanks for the info. This sounds like it would verify the presence of an open. We have verified that these balls are open and I am trying to figure out if we are fracturing or not wetting. causing these opens. I would use the die method on ne
Electronics Forum | Wed Aug 28 10:16:12 EDT 2002 | Jim M.
Sam We install a lot of die in the SMT room using same process as SMT parts.Water soluble solder paste is used for attachment of die to ceramic and boards. Biggest problem i found is the adjustment from installing the die in the bonding area. The t
Electronics Forum | Tue Aug 27 03:45:36 EDT 2002 | seje
Hi there. We are considering to attach die chip with solder paste to the pcb at the SMD line (we are used to attach it with silver epoxy at the die bonding line before). This is a whole new method to me, so I'd like to have some opinions here. Where
Electronics Forum | Fri Aug 30 06:18:55 EDT 2002 | seje
Thanks Jim, that should help. And yes, there is light at the end of the tunnel.... now : ) -Sasu-
Electronics Forum | Thu Jun 06 08:16:13 EDT 2002 | caldon
Jim- Sorry I can not offer advice on the Panasonic machine but do want to shed light on the Die and waffle pack issue. Take note that if the Die are loose in the pockets the balls or terminations could be damaged. The thin layer that the ball is atta
Electronics Forum | Fri Dec 07 09:54:05 EST 2012 | davef
Try MIL-STD-883 Method 2017 Die inspection service providers may be willing to help Services, Die inspection * Amkor amkor.com * Syagrus Systems syagrussystems.com SMTA has published a lot of papers that track to 'die' & 'inspection' but most oft
Electronics Forum | Wed Mar 29 18:17:16 EST 2000 | David
Does anybody out there have experience building electronics assemblies with DCA (Direct Chip Attach - bare die onto PCB) and wire bonding? - What Die Bonder/Dispensing Machines are recommended? - What brand conductive epoxy were used to attach die?
Electronics Forum | Tue Jan 09 22:04:48 EST 2007 | Guest
Set Up Guy, I am not sure if the COB you are refering to means Circuit on Board . If yes, this process also include SMT . Package is a combination of some passive components and bare die. Passives are normally attached thru SMT using solder te
Electronics Forum | Wed Sep 20 10:00:40 EDT 2000 | Erick Russell
Yes, some testing of soldering chip capacitors onto ceramic substrates with high temperature paste proved successful. Die attachment can be achieved using this technology as well. The underfill of the die becomes a critical factor in rework potentia
