Electronics Forum | Wed Jul 17 15:00:37 EDT 2013 | jmiller
what is the effect of pre-dip tank temp. and dip tank temp. on the thickness of the IAg?
Electronics Forum | Tue May 01 20:14:24 EDT 2001 | davef
We've been using a Glenpro 2143 Dip Tank [We offer bonus points for the wackiest retort on "dip tanks". Michael, I've got money on you.] to conformal coat boards. We can't find Glenpro. They used to be located on McBride Ave in Paterson NJ. Any c
Electronics Forum | Wed Oct 13 12:24:08 EDT 2004 | davef
Consider: * Equipment||Coating dip tank||Glenpro (2143 dip tank)||39 McBride Ave., Paterson, NJ 07501-1715 * Equipment||Coating dip tank||CCRCo||1954 Placentia Ave. Suite 107 Costa Mesa, CA 92627||800-443-2726 949-574-1360 Fax 1368 info@CCRCo.com ht
Electronics Forum | Mon Feb 14 12:28:04 EST 2000 | Dave F
Chris: I can't a semi-auto dip tank being any faster than manually dipping. Better control - yes. Less messy - yes. Other stuff Graham mentioned - yes. Have you discussed your goals with some of the used equipment folks listed in the archives?
Electronics Forum | Fri Oct 15 10:23:48 EDT 2004 | mrmaint
Matt, are there any discoloration of the pads on the raw boards. i have seen what we refer to as gray pads. Ran into this in the past and it turned out to be a problem at the board house with one of their dipping tanks. The proper levels for the proc
Electronics Forum | Fri Oct 29 17:44:13 EDT 2004 | davidcb
Davef, thanks for inputs. I think your correct, we have since obtained some ionic analysis and sure enough there is relatively high chlorides on the bare pcbs. The toluene is controlled within dip tank / drying system, almost no exposure to workers.
Electronics Forum | Thu May 04 11:42:05 EDT 2023 | proceng1
I did some further reading yesterday and an ultra-sonic dip tank seems to be the recommendation, using a BGA cleaning solvent. I am not sure how such a process would affect the populated side of the board.
Electronics Forum | Wed May 02 12:07:00 EDT 2001 | mparker
I was a bit amused the way you "tanked" that dip John. I mean you skewered him without benefit of remoulade, that puppy was tarred and feathered, chopped, chromed, toasted!!! I was a bit surprised that you chose to get back into the thread, it didn't
Electronics Forum | Wed May 02 16:20:01 EDT 2001 | mparker
As a second thought, just to address your problem, try contacting a local fabrication shop for restaurant supply. They are used to working with stainless steel. I once had a complete sink/workstation top fabricated to my specs. for a fraction of the
Electronics Forum | Wed May 02 22:33:44 EDT 2001 | davef
Silvio Dante (played by former E Street Band Guitarist Steve Van Zandt, in his acting debut) has even turned an extremely passing resemblance to Al Pacino [Godfather, Part III] into a personality; he�s forever curling down the corners of his mouth an
