Electronics Forum | Fri Aug 01 09:21:28 EDT 2014 | jimmyboz
Does it error during nozzle center check, if so, manually switch all holders to small, try center again. It should do about 8 small nozzle centers before error, if so this helps rule out the 10th station, if not check the 10th.
Electronics Forum | Fri May 30 09:53:19 EDT 2008 | cyber_wolf
"Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry " Thats what I meant when I said they
Electronics Forum | Fri May 30 09:50:04 EDT 2008 | jdengler
Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry
Electronics Forum | Mon Jun 19 14:14:12 EDT 2000 | pr
SMTRESEARCH.COM OR WPSALES are also options. There are lots of them out there who will supply just the discs, new nozzles, or do retips on your nozzles (cheaper) and all I've dealt with are cheaper than Fuji. As Kevin says your disc's need to be cons
Electronics Forum | Wed Jan 31 14:58:13 EST 2007 | pr
Is it the same nozzle every time? I would check that the shaft is hitting dead center (it could be binding)on the nozzles (especially if it only happens on 1 nozzle). Also check the rollers on the shaft (that hold the nozzle) and make sure they line
Electronics Forum | Fri Dec 08 17:31:17 EST 2023 | madisreivik
Changed camera, flicker is gone. But cannot calibrate nozzle centers with the narrow camera, error all time I checked buffer image, brightness and contrast is SAME as with wide camera. Center of camera is roughly aligned using nozzle, its better
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Wed Dec 06 17:22:03 EST 2023 | madisreivik
Hello and help ! After changing oil hose, cleaning machine and all nozzles, CP642 narrow camera started to flicker. And in nozzle centering measuring, no image at all. We checked syncro pin, seems ok. Also checked camera picture with Sony monitor,
Electronics Forum | Sat May 27 14:09:23 EDT 2000 | do ngoc hung
MAY YOU HELP ME TO SOVLE THE PROBLEMS IN MACHINE. I CAN NOT CHECK NOZZLES IN CENTER, BRIGHTNESS MODE OR THE CCD CAMERA CAN NOT CAPTURE THE NOZZLES. SO MAY I HAVE ANY INFO ABOUT IT. PLS GIVE ME A ADVICE ASAP VIA EMAIL. THANKS AND BEST REGARDS. DO
Electronics Forum | Tue Jul 19 18:08:28 EDT 2016 | dman97
Hello, I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles.
winsouce.jpg)
