Electronics Forum | Thu Jul 27 07:50:35 EDT 2006 | davef
Send us pix
Electronics Forum | Mon Jul 24 11:35:42 EDT 2006 | Jimk@ics-inc.org
We have experienced a problem with tin leaching or discoloration of lead terminals on random parts on solder side of a paste/paste operation. The profile has been used on previous production runs and there doesn't appear to be any heat damage to othe
Electronics Forum | Tue Jan 30 21:15:51 EST 2001 | davef
You seem to pretty far from shore to begin thinking about boats and floatation devices. Most laser trimmers are used by: * Semiconductor fabricators * Resistive component fabricators * Hybrid circuit assemblers Component fabricators and hybrid [
Electronics Forum | Mon Jul 19 16:03:39 EDT 2010 | warwolf
Agreed, on some components we have seen a "brownish tint" after reflow it doesn’t happen on all of our resistors it only appears to be on the leads, and have also seen the purpleish tint on some other 2512 components
Electronics Forum | Tue Sep 26 12:01:30 EDT 2006 | sliebl
We have solved our MCSB problems by using standard homeplate designs on all of our resistors and caps. I use a 50% taper and have achieved great results with 0402-1206 parts using both tin/lead and SAC305 paste. We use Amtech paste.
Electronics Forum | Wed Apr 29 07:46:52 EDT 1998 | Scott Davies
We would like to add another pick and place machine to the SMT line. We're low volume so we change the line over after each group of boards. So far we've pretty much ruled out Siplace in favor of the Universal machines. Does anyone care to share the
Electronics Forum | Thu Mar 24 18:16:24 EDT 2011 | bandjwet
Dear SMTNetters: Does anyone have a good method for determining the solderability of leaded high power resistors? We currently are using Dip and Look and they always pass yet solderability issues remain... Thanks! BWET
Electronics Forum | Thu May 05 12:31:27 EDT 2005 | russ
Not in this case, these BGAs were lead free and the profile used was for a lead part. I guess I will give you the whole story. These boards were sent to us from a customer to have the BGAs replaced for an unknown to us reason. We removed the parts
Electronics Forum | Thu Jul 20 12:51:50 EDT 2000 | Tekguy2000
We are currently running boards with resistor paks on the solder side of the board introducing these to the wave solder. We cannot get rid of shorting between the leads. We are using a water soluble acohol based flux. The option of going to selective
Electronics Forum | Mon Sep 21 20:45:55 EDT 2009 | davef
10.4. Pre-Cure Examination. Immediately after material application, the uncured conformal coating shall be examined for: a. Bubbles and Air Entrapments. These defects shall be broken by vacuum, with a sharp probe, or other appropriate tools. b. Bridg
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
