Electronics Forum | Mon Feb 11 22:05:44 EST 2002 | davef
You may not find a supplier with an "out of box" solution. But you might be able to jury-rig something without too much pain and cost. Try this: * Buy a fairly brainless feeder [like an old quad feeder] from an used equipment supplier / broker [sea
Electronics Forum | Mon Feb 10 14:34:56 EST 2014 | jigo91
Hi, I wanted to know how can we test our paste quality, as viscosity, temperature in which it is delivered to the SMT line and other variables that can affect our paste dispense or soldering. Our concerns are that paste quality may be causing solde
Electronics Forum | Wed Jul 27 10:07:16 EDT 2011 | swag
We bought air dispenser guns that fit the cartriges. I can't remember where we got them - sorry. We built little aluminum "holsters" for the sides of the machines to put the guns in. The guns are hooked up to air with low pressure regulators. Wor
Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue Jul 18 18:08:08 EDT 2023 | davef
Vote for: JBC DPM Paste Dispenser Manual Also consider: Metcal 910-MSG Manual Syringe Gun-Kit Spoty micro-dot solder paste syringe dispenser [ https://www.tindie.com/products/avandalen/spoty-micro-dot-solder-paste-syringe-dispenser/ ]
Electronics Forum | Fri Sep 07 16:37:47 EDT 2012 | burb1999
Ive used the Camalot long time ago to dispense paste on BGA pads after removal then reflow with a machine such as the AirVac. What is the best way to do BGA repair on pads? Ive read alot just reball the bga then put it back on? Todd
Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-
Electronics Forum | Tue Mar 18 07:53:39 EST 2003 | Paul Staniford
I am looking at dispensing solder paste using a Fuji GLV glue dispenser. This is to enable us to produce prototype pcb's without the need to purchase a stencil. Has anybody tried this before? If so what problems should I expect to encounter.
Electronics Forum | Fri Jul 09 11:19:58 EDT 1999 | Carol Brumfield
Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts.