Electronics Forum | Wed Jul 27 10:07:16 EDT 2011 | swag
We bought air dispenser guns that fit the cartriges. I can't remember where we got them - sorry. We built little aluminum "holsters" for the sides of the machines to put the guns in. The guns are hooked up to air with low pressure regulators. Wor
Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue Jul 18 18:08:08 EDT 2023 | davef
Vote for: JBC DPM Paste Dispenser Manual Also consider: Metcal 910-MSG Manual Syringe Gun-Kit Spoty micro-dot solder paste syringe dispenser [ https://www.tindie.com/products/avandalen/spoty-micro-dot-solder-paste-syringe-dispenser/ ]
Electronics Forum | Tue May 21 17:31:51 EDT 2013 | Maryem
Thank you for your suggestions, Is there any industrial supplier for solder paste dispensers?
Electronics Forum | Tue Jul 18 16:14:45 EDT 2023 | daniel_stanphill
I remember having seen an ad on LinkedIn or somewhere that showed a handheld pen capable of manual deposits even on 0402 and 0.4mm fine pitch pads. I have been trying to search for it today and am seeing some comparable products but nothing that look
Electronics Forum | Mon Feb 11 22:05:44 EST 2002 | davef
You may not find a supplier with an "out of box" solution. But you might be able to jury-rig something without too much pain and cost. Try this: * Buy a fairly brainless feeder [like an old quad feeder] from an used equipment supplier / broker [sea
Electronics Forum | Wed Mar 14 19:32:04 EDT 2012 | swag
You're not clear if you intend to reclaim and re-use the paste from the stencil or not. If not, then you should go to cartridges with an air gun or modify a caulking gun for dispensing paste from cartridges. The paste will last a long time.
Electronics Forum | Fri Jan 28 04:03:51 EST 2011 | grahamcooper22
Print then dispense in the areas you need extra paste. Why can you not use a stencil which has areas etched away around component patterns to thin the stencil down....for example a 150 micron thick stencil etched to 120 or 100 microns in specific are
Electronics Forum | Tue May 14 15:21:07 EDT 2013 | Keith Cathcart
I've seen a couple of customers create a jar dispenser similar to the ones you can buy for beverage cans. See this link for the examples used for beverage cans http://www.meijer.com/shop/chrome-organization-kitchen-storage.jsp Hope this helps. Kei
