Electronics Forum | Wed Jan 09 12:41:12 EST 2008 | robotek
Please advise if you have any sources for used/refurbished/repair services for Camelot Gemini 1 glue dispenser flat panel display monitors. Thanks, jason@robo-tek.com
Electronics Forum | Fri Dec 21 21:02:18 EST 2018 | vinzon02
Hi Team; Does anybody here had a copy of the guideline on Glue dispense standard size specs per component? Currently we are using Camelot dispensing equipment. I'm on the process of making control document on glue size. Please help share IPC stan
Electronics Forum | Wed Sep 15 11:14:35 EDT 1999 | Darren
Does anyone know the best way to program my Camelot glue dispenser off line? I really like the machine, it just takes me too long to program it. We do contract work so I can get gerber data for all (most) of my assemblies. I need to get these progr
Electronics Forum | Wed Sep 15 12:02:19 EDT 1999 | Jim Trent
| Does anyone know the best way to program my Camelot glue dispenser off line? I really like the machine, it just takes me too long to program it. We do contract work so I can get gerber data for all (most) of my assemblies. I need to get these pro
Electronics Forum | Wed Nov 13 16:20:38 EST 2024 | auriga2001
When it goes through its homing operation, does it indicate that the sequence ran through correctly? Will it let you go into a programming mode where you can trackball around?
Electronics Forum | Wed Sep 15 18:43:58 EDT 1999 | Bob Ferguson
CAMALOT have a really good conversion system, COPS. It takes the placment machine data, which you have to generate anyway, and converts this instantly to the glue or solder pattern of the board required. You can also edit this file to change all the
Electronics Forum | Thu Jul 20 13:58:47 EDT 2000 | Bob Willis
Well you can do both but why clinch the leads ? You are not referring to the SPOT process my friends at Camelot talked about some years back are you ? You can dispense paste but it�s a lot slower than printing. You can select a pin and dispense dire
Electronics Forum | Wed Aug 12 12:32:56 EDT 1998 | Rich Croteau
Have an SRT w/preheat, 18 layer board all copper, 456 BGA needs to be removed and replaced. The manufacturer is Chip Express and during reflow it warps up or down. Causing either opens or shorts on the corners. I was using gel flux with multiple p
Electronics Forum | Wed Sep 15 16:18:16 EDT 1999 | Jason Gregory
| | Does anyone know the best way to program my Camelot glue dispenser off line? I really like the machine, it just takes me too long to program it. We do contract work so I can get gerber data for all (most) of my assemblies. I need to get these p
Electronics Forum | Wed Nov 13 19:33:40 EST 2024 | youngbuck
Hi,Aurigna2001 Yes, when we put in trace mode it goes to home position without any errors. It will let us load program and but when you click on the x y and try to roll the x,y around with the trackball it doesn't move anything. Also, it doesn't mov
