Electronics Forum | Tue Nov 24 13:37:27 EST 2015 | ttheis
A shot of the screen is attached showing the version information. Where do I find the filters? It looks like the power goes from the switch to the large power distribution box which I presume has the back-up batteries inside. What method is recomme
Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
Electronics Forum | Mon Jun 01 09:29:22 EDT 2015 | tnisbet
Did you change the Z-Axis amplifier? Do you have the old black unit or the new retro(blue box)? Have you checked the rear distribution board for a bad or burnt connection? If you haver any further questions please contact george@goppm.com
Electronics Forum | Tue Dec 22 15:10:57 EST 2020 | ilavu
Tom, There are two power supply in the machine. One on top of VME box and other behind power distribution panel. The voltage that you see and check at PDP is not from VME.
Electronics Forum | Tue May 16 02:12:58 EDT 2017 | robl
Hi Anthony, Hopefully some of the following may help: 1) Electrics - do you know the rating of each machine and the total load, and can your distribution box take it? Do you have the correct cabling and connectors in place to just plug the machines
Electronics Forum | Thu Aug 13 19:54:01 EDT 2015 | aemery
The camera assembly is designated as X23; the stencil & board lighting as well as the camera video signal pass through the DB9 connector at the camera. There is a ribbon cable in the vision gantry tray that carries both to the box on the left side o
Electronics Forum | Fri Apr 30 14:37:59 EDT 1999 | Stefan Witte
| I am looking for a good splicing kit at a reasonable cost. Any suggestions would be appreciated. | You may want to try a product out of Germany, which does not require a tool. SMD Double Splice Tape from Steier Tesa. Tel.: 011 49 41214 730. Tesa
Electronics Forum | Sat Jun 08 13:16:06 EDT 2013 | unisoft
Take a look at the Unisoft software ( http://www.unisoft-cim.com ). For over 25 years this software has in use by Electronics Manufacturer CEM/EMS's and OEM's to automate New Product Introduction (NPI). It's perfect for Electronic Contract Manufact
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Tue Apr 01 07:21:16 EDT 2008 | davef
First, your idea of having a safety glass policy is good. The glasses should meet ANSI Z87.1-2003. [Although, ANSI Z87.1-1989 and ANSI Z87.1 are fine for electronic assembly.] Here's a comparison of the 1989 and 2003 standards: http://www.tasco-safet
| 1 |
