Electronics Forum | Thu Oct 19 09:39:53 EDT 2000 | NLykus
Great information. Your all right in my book "Dave F". Thanks for your help. Will redesign D.O.E. with more refined profiles for the different materials and let you know how it goes. Take care N. Lykus
Electronics Forum | Fri Oct 06 05:56:37 EDT 2000 | Alberto Silva
Hi, Instead of using High Temp solder, I would like to use a UV epoxy to atach termocouples to reflow profile boards. Does any one know a good one? Thanks in advance. Alberto
Electronics Forum | Wed Mar 28 14:40:13 EDT 2007 | amelara98
Unfortunately, the facility overseas does not have a profiler. We suspect it is overheating due to a thick pallet and a raised temperature to compensate for it.
Electronics Forum | Thu May 21 08:29:05 EDT 2015 | cyber_wolf
DeanM, How do you verify you have great results with the AutoSet feature if you do not check your profiles ? How does the AutoSet take into account large ground planes on certain areas of the board ? just curious
Electronics Forum | Mon Dec 17 12:26:17 EST 2007 | slthomas
In addition to what robqd3 said, just because you can set your oven to 300� C doesn't mean that (a) it's providing 300� C air, or (b) that your oven will survive the temperatures required to reflow your boards properly. Confirming (a) does mean pro
Electronics Forum | Thu Apr 09 12:11:19 EDT 1998 | raymond
Does anyone has any experience using the Prophet Thermal Manager by KIC Thermal Profiling for real time monitoring and control of reflow oven profile ?
Electronics Forum | Thu Apr 09 12:35:16 EDT 1998 | Earl Moon
| Does anyone has any experience using the Prophet Thermal Manager by KIC Thermal Profiling for real time monitoring and control of reflow oven profile ? Yes. What is your concern. Earl Moon
Electronics Forum | Fri May 22 19:21:48 EDT 1998 | Dave F
Recently there was a thread on soldering paladium leads on ICs. A gent from TI suggested an article he had written. Various folks suggested making sure the reflow profile peaked above 215C. My question is: How does one recognize paladium leads so
Electronics Forum | Mon Sep 27 10:49:51 EDT 2004 | marc
Gary Getting the specs for a used machine will be tough from Ersa but at least send them a note, the seller should also be able to get the info for you. In regards a 5 zone system. I would suggest at least 7+ zones if your moving to lead free.
Electronics Forum | Wed Apr 28 15:08:10 EDT 2004 | russ
This could be a long shot but here goes. I have found that if flux is applied in excess that it will actually "move the solderballs" during reflow. I have actually seen where the balls are completely outside the package and oviously there are short
