Electronics Forum | Wed Feb 06 07:02:31 EST 2019 | liquidspacie
We've found the problem. It was fault scale encoder. Swapping cards didn't help. Thanks everyone for the input.
Electronics Forum | Mon Jan 28 13:58:41 EST 2019 | oxygensmd
1. switch the axis cards 2. switch the axis servo cards 3. make sure the distance between scale and encoder is 400um 4. check the signal by oscilloscope, adjust to have the right signal 5. replace the scale or encoder
Electronics Forum | Wed Feb 06 06:14:01 EST 2019 | youngbuck
Try changing conversion board. 2 big ribbon cables plug in to it. p./n 00321189. or the 2 ribbon cables may need to be reseated. Thanks, Ryan
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Sun Sep 09 08:38:14 EDT 2018 | devinpcb
I have found the paste flux is the worst. It leaves a black residue that can corrode.
Electronics Forum | Wed Aug 27 14:38:20 EDT 2008 | rgduval
Does your paste provider recommend a TAL? For the leaded and lead-free pastes that we use, the manufacturer recommends 60 seconds above liquidous. I note that your profile shows the TAL as 30 seconds, which may not be sufficient. That said, tho
Electronics Forum | Thu Feb 05 13:27:39 EST 2015 | spoiltforchoice
I'm not familiar with your machine but is it possible that this dll file is looking for a security dongle of some kind ? This might be a small USB key, a USB device installed on one of the internal headers on the motherboard or something on a serial/
Electronics Forum | Tue Apr 27 16:42:18 EDT 2010 | m79d
Hi jepoy + a very frazzled man thanks for your suggestions,here is how it went:- I found a couple of these VM1710 boards and tried one and still nothing. I really wanted to see if power was getting to the camera and anything coming out. I was loo
Electronics Forum | Mon Jan 06 21:23:21 EST 2025 | lundail
Hello, We recently purchased an MPM 100 screen printer on an auction. The machine was supposedly working but we cant get it to boot up. On launching the software we get the following "Connection failed with the following error:'Vision not connected'
Electronics Forum | Thu Oct 02 04:39:08 EDT 2014 | oxygensmd
I had the same problem with my E5. At first check the cover and valves in the squeegees head. For me wasn't help, I didn't found any fault, jamm. In my machine there is two adjustable valve over the transport at output-vent. I tried to readjust the
