Electronics Forum | Thu Jul 15 15:41:00 EDT 1999 | Doug
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Thu Jul 15 14:55:24 EDT 1999 | JohnW
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Mon May 08 08:54:28 EDT 2000 | Lee Radney
Ok... Anybody got any quick, low cost ideas that can help me here? We run various panel layouts (all products are same width) thru our reflow oven. The problem is that due to the different layouts of our panels, the moveable center support chain
Electronics Forum | Sun Oct 03 18:26:17 EDT 1999 | park
What are pro's and con's of reflowing top side first and curing bottom side chip components, and then wave soldering bottom side? How about curing bottom side first and reflowing top side later? What percentage of companies run reflow/cure/wave for
Electronics Forum | Thu Sep 23 06:01:16 EDT 1999 | joel cruz
| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double s
Electronics Forum | Thu Sep 23 06:06:20 EDT 1999 | joel cruz
| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double s
Electronics Forum | Wed Sep 15 06:14:16 EDT 1999 | Wayne S.
| I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | Hello, you can get some insight by typing in double sided boa
Electronics Forum | Mon Oct 04 12:18:43 EDT 1999 | RICK_EEI
Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding sold
Electronics Forum | Mon Oct 29 15:58:47 EST 2001 | davef
Kitting: Buy-in material in kit form that is complete and in the proper form. Line set-up: Layout all boards to be the same width. Printer set-up: Use a dispenser, instead of a printer. Dispenser set-up: Program & debug off-line. Placement machin
Electronics Forum | Sun Oct 03 21:36:57 EDT 1999 | JAX
| What are pro's and con's of reflowing top side first and curing bottom side chip components, and then wave soldering bottom side? | | How about curing bottom side first and reflowing top side later? | | What percentage of companies run reflow/cur