Electronics Forum | Thu Jun 22 11:02:13 EDT 2000 | Chrys Shea
Jason, Double sided reflow should be no problem. People have been doing it for years. The surface tension of the molten solder will hold the components on the bottom side during your second pass. This is almost always the case, unless you have re
Electronics Forum | Thu Jun 22 11:01:54 EDT 2000 | Chrys Shea
Jason, Double sided reflow should be no problem. People have been doing it for years. The surface tension of the molten solder will hold the components on the bottom side during your second pass. This is almost always the case, unless you have re
Electronics Forum | Tue Feb 04 18:46:01 EST 2003 | slthomas
"Use the pad mating to lead wetting area." If I get your drift, we're talking about the minimum lead area (assuming the pad has an area that's at least as large as the lead) required to be wetted by IPC-610. Hmmmm...that would take some calculation
Electronics Forum | Tue Feb 09 11:23:25 EST 1999 | michele sommaruga
I would like to have information about the processability of different packages. In particular I would like to known for which package I can use a double reflow for soldering. Best Regards
Electronics Forum | Tue Sep 11 09:13:01 EDT 2001 | davef
Like most things in electronic assembly, this is not astrophysics. People have pasted boards, placed components, turned the board up-side down, run the board through a reflow oven, and generalized about which components: * Fall off the board. * Don
Electronics Forum | Tue Feb 09 13:07:00 EST 1999 | ETS - Brian Stumm
By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | I would like to have information about the processability of different packages. | In particular I would like to known for which package I can use
Electronics Forum | Wed Feb 10 07:50:52 EST 1999 | michele sommaruga
I am referring to reflowing twice. Fist time I reflow the up side, turn the PCB and reflow the bottom side. | By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | | | | I would like to have informat
Electronics Forum | Tue Jun 13 21:53:31 EDT 2000 | Dave F
This site is dedicated to double sided reflow and solder balls. Wasssup?
Electronics Forum | Tue Jun 13 21:18:02 EDT 2000 | sachi
is there a site or any information available for double sided reflow? Our compnay is rather new to this proceess and before we get deep i'd like to know more about it.
Electronics Forum | Tue May 07 22:25:15 EDT 2002 | L_ch
Hello, As you know for the double side assembly PCBs, we normally first place the bottom side, then place top side after reflow soldering of bottom side. are there any other considerations for the sequence of reflow soldering ( bottoms side first, to
winsouce.jpg)
