Electronics Forum | Thu Jul 27 12:30:37 EDT 2006 | Rob
Hi David, we used the following techniques in high volume production, depending on the type of flexi-board: (all were in milled pockets in a durastone pallet) 1) Kapton tape top & bottom 2) Spray mount & samll amount of kapton tape (you only had
Electronics Forum | Tue Feb 09 11:23:25 EST 1999 | michele sommaruga
I would like to have information about the processability of different packages. In particular I would like to known for which package I can use a double reflow for soldering. Best Regards
Electronics Forum | Thu Oct 13 00:18:36 EDT 2011 | kemasta
Hi! We have many PCBA with double side BGA mounted, current practice is to put the board on reflow pallet (durastone 761) to cover BGA at bottom side so that the BGA won't lift after go through reflow oven, but this created 2 problems:- 1) We need t
Electronics Forum | Thu Oct 13 16:08:11 EDT 2011 | davef
BGA solder joint reliability is actually improved slightly from a double-sided reflow. [Jean-Paul Clech APEX 2003 Solder Joint Reliability of BGA Assemblies]
Electronics Forum | Tue Feb 09 13:07:00 EST 1999 | ETS - Brian Stumm
By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | I would like to have information about the processability of different packages. | In particular I would like to known for which package I can use
Electronics Forum | Wed Feb 10 07:50:52 EST 1999 | michele sommaruga
I am referring to reflowing twice. Fist time I reflow the up side, turn the PCB and reflow the bottom side. | By double reflow are you referring to double sided reflow? Or are you referring to reflowing twice? | | | | I would like to have informat
Electronics Forum | Tue Jun 13 21:53:31 EDT 2000 | Dave F
This site is dedicated to double sided reflow and solder balls. Wasssup?
Electronics Forum | Tue Jun 13 21:18:02 EDT 2000 | sachi
is there a site or any information available for double sided reflow? Our compnay is rather new to this proceess and before we get deep i'd like to know more about it.
Electronics Forum | Tue May 07 22:25:15 EDT 2002 | L_ch
Hello, As you know for the double side assembly PCBs, we normally first place the bottom side, then place top side after reflow soldering of bottom side. are there any other considerations for the sequence of reflow soldering ( bottoms side first, to
Electronics Forum | Thu Jun 15 13:01:35 EDT 2000 | Dave F
Thank you Michael.
