Electronics Forum | Thu Sep 23 06:01:16 EDT 1999 | joel cruz
| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double s
Electronics Forum | Thu Sep 23 06:06:20 EDT 1999 | joel cruz
| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double s
Electronics Forum | Wed Sep 15 06:14:16 EDT 1999 | Wayne S.
| I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | Hello, you can get some insight by typing in double sided boa
Electronics Forum | Mon Oct 04 12:18:43 EDT 1999 | RICK_EEI
Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding sold
Electronics Forum | Fri Oct 26 11:37:27 EDT 2001 | Dave G
You could start by putting together a matrix of P/N's vs product. This will tell you which parts are common with most of your jobs. These would then become part of a fixed feeder setup that would stay on the machine. (These will probably be mostly R'
Electronics Forum | Mon Oct 29 15:58:47 EST 2001 | davef
Kitting: Buy-in material in kit form that is complete and in the proper form. Line set-up: Layout all boards to be the same width. Printer set-up: Use a dispenser, instead of a printer. Dispenser set-up: Program & debug off-line. Placement machin
Electronics Forum | Fri Dec 19 07:31:58 EST 2008 | realchunks
Ersa selective solder machines for us. We have 5 dual pot machines and run double sided reflow - double sided thru hole.
Electronics Forum | Mon Oct 02 05:45:41 EDT 2006 | Thomas
Hello, Have anyone of you any experience of mounting BGA-s on both side of the PCB in lead free process? Have you seen any problems after the second reflow? Is it something special to focus on? /Thomas
Electronics Forum | Wed Mar 14 17:33:42 EST 2001 | davef
Check Bob Willis' site. He calls this Single Side Multipass Endothermic Elongated Happy Reflow Soldering, er someting like that. Ha ha ha!!! Naw, he calls it Simultaneous Double-Sided Reflow Soldering. That might be something like you are talking
Electronics Forum | Tue Oct 03 13:08:39 EDT 2006 | Moby
This is an issue that we are seeing a lot! It used to be that the primary-side (component-side...top-side) had most of the active components. It was simple: reflow bottom first. Now, we are seeing both sides of the assembly having the same amount of