Electronics Forum | Fri Feb 23 15:31:31 EST 2007 | realchunks
Running the BGA first is OK. We run double sided BGA baords all the time without problem.
Electronics Forum | Tue Jun 13 21:53:31 EDT 2000 | Dave F
This site is dedicated to double sided reflow and solder balls. Wasssup?
Electronics Forum | Tue Jun 13 21:18:02 EDT 2000 | sachi
is there a site or any information available for double sided reflow? Our compnay is rather new to this proceess and before we get deep i'd like to know more about it.
Electronics Forum | Tue Sep 14 18:33:38 EDT 1999 | Mark Belec
I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts.
Electronics Forum | Thu Jun 15 13:01:35 EDT 2000 | Dave F
Thank you Michael.
Electronics Forum | Fri Jun 23 09:53:40 EDT 2000 | Bob Willis
Also I suggest you read through the Charity Report I produced on the specifi process of Double Sided Reflow Assembly which you can also get from the SMTA. All the money from the sale of the report goes to the Charles Hutchins Scholarship Fund which T
Electronics Forum | Fri Jun 23 10:29:51 EDT 2000 | Bob Willis
Also I suggest you read through the Charity Report I produced on the specifi process of Double Sided Reflow Assembly which you can also get from the SMTA. All the money from the sale of the report goes to the Charles Hutchins Scholarship Fund which T
Electronics Forum | Tue Feb 04 09:12:40 EST 2003 | davef
Near the top of Phil's front page is thin blue bar with white lettering that extends horizontally across the page. Click on the word "articles" on that blue bar. It will turn a rusty-brown and load another page. On that page, click on the article
Electronics Forum | Wed Jun 21 22:07:09 EDT 2000 | Jason
We are going to try double sided reflow for the first time. Can we use the same 63/37 paste on both sides? The board also has bare copper pads i'm pretty sure. will this present any challenges? The bottom side has a QFP on it. Should it stay on?
Electronics Forum | Mon Feb 03 20:23:48 EST 2003 | davef
Use the pad mating to lead wetting area. Check: * Phil Zarrow's site [ http://www.itmconsulting.org ] for a paper. * Bob Willis may have something on his site [ http://www.bobwillis.co.uk ]. He has been very involved in developing this measure. * F