Electronics Forum | Fri Oct 05 11:59:54 EDT 2001 | mparker
I am looking to learn of possible causes and solutions for the following problem. A potential customer is demanding that I use a saponifier in the aqueous wash, he has lab test results of former CM's products that leads him to believe it is necessar
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
Electronics Forum | Fri Aug 28 17:24:28 EDT 2020 | stephendo
Did you check all the voltages and fuses? The second worst is when a machine is down for a while and it ends up being something basic. The worst is when it started as something basic and someone introduces a new problem. Also could there be any opti
Electronics Forum | Tue Dec 29 17:42:27 EST 1998 | Dave F
| Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. | | The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. | W
Electronics Forum | Tue Aug 02 11:17:27 EDT 2005 | Stefan
Tape feeders usually have a fixed pick position regardless of the package size. Is the component body off center in the tape pocket? I hope you can enter an offset in the feeder set up file. Also, perforation holes can deform, if the reel is too hea
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
Electronics Forum | Tue Jan 23 13:41:44 EST 2007 | chrisgriffin
What exactly do you mean by "side clamps"? If you mean the thin strips of metal that the board is pushed up against, they are adjustable. Maybe a little more squeege force or down stop also.
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Mon Jul 17 07:26:59 EDT 2006 | aj
Guys, I have an annoying problem on the above mentioned machine. Basically, when the machine loads a board it sits and waits at the down stop until it times out. All sensors on the rail system work fine in the IO's, aswell as the board stop sensor
Electronics Forum | Fri Mar 18 19:17:37 EST 2005 | valuems
Hello PMD Don't feel like that, we live with these MPM's. And we have over 10 years experience. Also never mess with the down stop on any MPM and you will be better off. Most of mpm's machines have a down stop of .0750 and it should never be cha
.png)
