Electronics Forum | Mon Jul 17 16:29:18 EDT 2006 | aj
Rail widths are fine. The board loads from the previous conveyor and hits the down stop and flags the sensor... It will sit there and time out unless I flag the left rail sensor. It will work properly every now and again. All sensors work fine in t
Electronics Forum | Fri Jan 16 16:57:14 EST 2015 | dilogic
I doubt you will be able to get satisfactory results with 0201. 0402 is another story. When doing 0402 projects, we use only electric (MP) feeders and always at the same feeder slots (feeder teach done for each of them). MPF08 nozzle works fine. Also
Electronics Forum | Fri Apr 05 18:33:31 EDT 2019 | ttheis
I am also interested in this but to slow one of our machines down- it stops too quickly and shakes the machine more than I would like. We are running GSM1's on OS/2 and uic sw 3.3.
Electronics Forum | Fri Sep 13 14:22:37 EDT 2002 | davef
If that's the case, it's most likely the radio is bad. Again, I'm not clear, but it sounds like using the MD is the trigger to shut the player down: * Stop using the MD. * Fix the MD or some of the associated power supply regulation circuitry. For
Electronics Forum | Wed Jun 09 16:54:24 EDT 2004 | Ralf
Hi all I have a question to all of you who has experiences with Microflex MPM. There are two items: one is on contact calibration and second squeegee pressure calibration. Do i have to if i set PCB make these calibration?. Does Microflex have mechani
Electronics Forum | Tue Jun 29 13:42:20 EDT 2004 | sigmaprint
You will need to set the contact and squeegee zero calibration every time you set up a new product, we do this because the thickness of the substrate (pcb) can change between product and this will effect these calibration settings. The machine does n
Electronics Forum | Tue Mar 20 10:27:36 EDT 2007 | davef
Print styles: Print - Most common print mode * A single print stroke forward on first board * A single print stroke reverse on next board Print-Print (Double Print) * Both forward and reverse printing strokes * Helps to ensure complete filling of th
Electronics Forum | Sat Mar 29 15:29:06 EDT 2008 | aw
I am printing a ceramic paste through a 160 mesh screen that should have a theoretical wet print thickness of 53um but the only way I can get the print that thin is to increase down stop and slow the stroke. This is causing problems with the mesh, s
Electronics Forum | Wed Sep 01 12:07:31 EDT 2010 | davef
Printing solder paste * Use single stroke, on-contact print cycle * Ensure the substrate is well supported, especially under areas of fine pitch print. * Select pressures of about 1- 2 lbs per linear inch of squeegee blade [Set squeegee pressure hig
Electronics Forum | Wed Oct 01 15:24:55 EDT 2014 | horchak
are you trying to lengthen or shorten the lead length? Lengthening the amount of lead being cut off and going into the scrap tube will shorten the lead length. Lead length is pretty much determined by the down stop setting on the insertion head, the
.gif)
