Electronics Forum | Wed Feb 02 21:56:11 EST 2005 | davef
Based on X-ray imaging, IPC-7095 standard specifies three categories for void size for BGA solder joints. These categories are based on the percentage of joint cross sectional area occupied by the voided area. Class III Small: Void area is LT 9% Cla
Electronics Forum | Wed Feb 02 16:24:14 EST 2005 | bobsavenger
I would like to know if anyone has an IPC specification for BGA's handy? I'm looking for specifics based on Classification. Roundness, %voids, size, etc. Please let me know if you have this. Thanks Bob
Electronics Forum | Wed Dec 11 07:05:28 EST 2019 | ameenullakhan
Hi, Below may help you out. per IPC 7093 ( Design and assembly Process Implementation for Bottom Termination Components ),Clause 6.1.5.3 voids on thermal pad up to 50% does not result in loss of thermal performance. Since the void criteria is
Electronics Forum | Thu Oct 11 13:10:04 EDT 2012 | anvil1021
We are experimenting with void control in reflow and have had pretty good luck for the most part in attaining Class lll IPC spec. but we have seen a sudden increase in voiding on a specific product and I was wondering if anyone has seen this extreme
Electronics Forum | Fri Sep 03 06:53:38 EDT 2010 | arjan
Yes, we assembled a lot of QFN in the last years, but we don't have a X-ray machine by ourself, so we cant't inspect each device. This type LGA was designed on a prototyping board of our customer so we would validate our LGA reflow process and a rese
Electronics Forum | Thu Sep 02 07:50:27 EDT 2010 | sachu_70
Just to add to my comments,solder joint voids do occur in LGA. Voids in LGA can be larger due to geometry and greater ratio of flux to solder. IPC-A-610D specifies a greater than 25% voided area is a defect for BGA, however, it does not specify the d
Electronics Forum | Tue Jul 02 02:50:55 EDT 2002 | ianchan
Hi mates, was going thru the IPC-A-610C Standards, and noted BGA voids stands somewhere between 10%-25% voids permissible in the solder "ball" bump, after reflow process. Was wondering, hypothetical case study, is there any specification for voids
Electronics Forum | Thu Sep 09 05:23:10 EDT 2010 | 15009
You can reduce and almost eliminate voids and other paste related defects in LGA's BGA's, QFN's etc, by using solid solder deposit. Its been around for 24 years, 13 in the US. It is now included in the new IPC 7093 specification for bottom terminat
Electronics Forum | Thu Oct 26 18:10:11 EDT 2000 | ptvianc
Philip: Cases 1-3, those criteria may be specified in more recent versions of ANSI/J-STD-001 and/or ANSI/IPC-A-610. Unfortunately, I do not have any new versions of these specs. that may cover these points. As for voids in BGA joints, I have not
Electronics Forum | Tue Jul 26 08:20:46 EDT 2005 | Bob R.
All you can do is try it. I did a literature search last year on causes of BGA voiding and came up with a pretty long list, sometimes contradictory. I also discussed it with several paste suppliers. What I came away with is that what aggravates voi
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100
