Electronics Forum | Sun Jan 18 02:52:28 EST 2015 | dilogic
I've successfully networked our GSM's. They all run OS/2 Warp 3.0 which already has drivers for the card. Which OS/2 version your machine runs on?
Electronics Forum | Wed Dec 09 17:12:08 EST 2015 | ttheis
Hi Travis- We're trying to do the same thing. Did you have any luck finding the driver disks for the EXM-10A card?
Electronics Forum | Fri Jan 16 15:29:48 EST 2015 | travishemen
We are trying to network our Universal VCD 8 and Radial 8. I have everything I need except for the driver disks for the Radisys EXM-10A network card. Does anyone have a copy they would be willing to share?
Electronics Forum | Fri Jan 16 16:59:31 EST 2015 | dilogic
We do not have such machines, only GSM's but network card is the same. Is Radial (VCD8) running on OS/2 too?
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Thu Jan 15 15:36:11 EST 2009 | babe7362000
Sounds like the driver card to me if it switched directions from the Y to the X when they swapped the boards
Electronics Forum | Wed Apr 08 18:47:57 EDT 2009 | swag
Could be the z-axis driver card???
Electronics Forum | Wed Nov 26 18:17:26 EST 2014 | rhcriad
Thanks SWAG. I will clean up all of the connectors, reseat and hope for the best!
Electronics Forum | Thu Sep 24 07:18:27 EDT 2015 | anilwagh
Check all axis driver card,input supply connector may burn.
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
.png)
