Electronics Forum | Wed Nov 23 07:45:39 EST 2016 | bukas
hello, I have a GSM2 machine with faulty motor driver (i guess), usually when this error occurs i would rest it via button on a panel several times, but this time it doesnt work. what should i check/ measure to locate this problem? there is 7 blink
Electronics Forum | Mon Apr 11 06:54:03 EDT 2011 | mosborne1
Wipe off your linear scales and clean your quadalign lense.
Electronics Forum | Wed Feb 23 13:50:55 EST 2005 | c.b
I am currently using a quad 1000, and up to now it has been a good reliable machine upto yesterday. I now have an error message that reads "driver error, emergency stop" the machine then freezea and will not run. Could some one please tell me if t
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Fri Dec 22 20:28:44 EST 2017 | 1232kade
Hi everybody. I have some problem that i cant solve, someone pls help me... My Mounter Juki FX-1R cant origin. When i try to origin, the problem appear ( see attach image ) I can control air devices like ATC plate, nozzle,... But cant origin and cont
Electronics Forum | Wed Sep 30 20:53:27 EDT 2020 | emeto
Motor and motor driver are involved in the equation as well.
Electronics Forum | Wed Sep 30 20:35:51 EDT 2020 | erici
Hi all, was wondering if you have any ideas on how to correct the problem we are encountering with our S25 machine. The machine is giving an X-axis counting error at gantry 1. I replaced the x-axis linear reader and the linear scale as well, but st
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Thu Aug 29 14:20:17 EDT 2013 | nophsem
Thanks for the response bobpan! LED's on the driver cards work well (green with doors closed and both red&green on with door open), and I don't use the carts. The head doesn't move after power on and inmediately you can listen alarm.
