Electronics Forum | Thu Dec 08 22:57:45 EST 2016 | ttheis
I'm not too experienced with this but what about an air-blast with an ionized air source such as an air knife above and below a conveyor to push most of the fluid off of the pcba then run through an oven just above vaporization temperature.
Electronics Forum | Wed Apr 08 15:40:20 EDT 2015 | kevinb
I would like to find somebody that uses Hysol, (Loctite) material GR 9810-1P. I would like to see how it molds and see if they could part with some of this material for us to try. We are willing to pay for a trial sample. I can go to Hysol but the
Electronics Forum | Tue Feb 11 09:01:54 EST 2014 | emeto
You should get your paste in ice(dry ice). Then you should keep it in a fridge. Many pastes now have 1month shelf life(after you take it out of the fridge). If you follow all the above, you might be having: 1. Lot problem - try different lots of you
Electronics Forum | Fri Sep 20 06:40:41 EDT 2024 | mgzhang
i would like to know detail of your cleaning process: which kind of cleaning machine you are using right now for cleaning PCBA board, as i know, 1、Dry ice cleaning machine 2、water based cleaning machine for deep cleaning 3、tape type cleaning machine
Electronics Forum | Sun Dec 09 22:54:20 EST 2001 | dburr
It sound you have already discovered to root cause, flux entrapment in the via holes. Short of changing the desing, here are sone suggestions. The main thing is you have to dry out the via holes of the wet flux. Some things to try are: slow down t
Electronics Forum | Fri Nov 18 09:21:41 EST 2016 | sumote
Lazy operators empowered by management. Sounds like you may have some nepotism? Since it falls to you to clean up someone else’s mess I have an idea for you. I once worked for a company that had a large wash sink with a hand sprayer very similar to
Electronics Forum | Thu Mar 03 09:11:25 EST 2005 | russ
I wouldn't raise the temps just slow the conveyor, You need to get the PCB "soaked in". It seems as if you are applying more thermal energy than the PCB can accept in all areas. Does this oven have convection heating? Hopefully so. I have found t
Electronics Forum | Fri May 14 16:08:38 EDT 1999 | Chrys Shea
| | | | | I am looking for anyone who has converted over to VOC Free flux. I need some info on any problems, etc. that you might have had. | | | | | | | | | | Please E-mail me at wes.ruggles@vickers-systems.com or call at (513) 494-5229 | | | | | |
Electronics Forum | Mon Nov 05 20:34:03 EST 2001 | davef
What�s the problem? There area many heat related failure mechanisms in bare boards. You can damage boards with heat several ways. A couple favorites [Don�t try this at home. Perform on a closed track by professional solders only.] are: * Put a
Electronics Forum | Fri Feb 25 02:30:32 EST 2011 | pkannan
Dstadem, Thanks for bringing your in valuable experience with the J STD 005 " Requirements of Solder Paste". I fully agree with you that the Solder Paste can be qualified for shelf life by doing simple viscosity test and visual inspection for coal
