Electronics Forum | Tue Sep 18 15:15:10 EDT 2007 | jdengler
Jeff, You assume too much. Not all VCD's had clinch in sensors. Darron did not tell us what vintage this machine is so what habsfan said could be the problem. We need more information to help. Does the machine stop when it doesn't cut the lead? D
Electronics Forum | Mon Sep 17 14:45:10 EDT 2007 | jeffharley
Are you using adjustable workboard holders or dedicated ones? Are both heads lined up exactly the same(using the b.e.c. template? Are parts formed correctly and lined up with the component holes on both sides(heads)?
Electronics Forum | Thu Sep 13 17:29:02 EDT 2007 | fnorradd
I am currently having a problem with uncut legs on one side of axial components from a universal dual head insertion machine. Initially it was thought that the anvil on one side was engaging slow so I stripped down and changed the seals in the botto
Electronics Forum | Fri Sep 14 10:42:03 EDT 2007 | slthomas
Are you sure the anvil is coming up? You might try running a program w/o parts or boards (no continuity check) and watching to see if everything is moving when it should be. Do you use continuity checking? If so, what are the results?
Electronics Forum | Tue Sep 18 08:14:31 EDT 2007 | jeffharley
This would not produce the condition that Darron is seeking help for as the vcd would stop due to not seeing a clinch in signal with a mechanical jam.
Electronics Forum | Mon Sep 17 21:20:53 EDT 2007 | molos21
You should check your back stroke of the cutter. The backstroke is probably too long which cause a mechanical jam when you fire the cut and clinch. The anvil goes up first and then come the cut and clinch at this point the jam should appear. There is
Electronics Forum | Tue Sep 18 18:03:52 EDT 2007 | fnorradd
Thanks for all of the informations guys, after spending some time rechecking the set ups and checking for worn components in case there was something i missed, i then took some time whilst an operator ran the machine to watch. Whilst doing this i no
Electronics Forum | Tue Sep 18 16:30:29 EDT 2007 | slthomas
I think Darron drove that DHVCD off'n a tall cliff. There's a whole bunch of stuff that could cause no-cuts, but without more information (dings on leads, full insertion, dry-run performance, continuity checking results) we'd all be (and have been)
Electronics Forum | Wed Nov 11 00:42:15 EST 1998 | Jason
Mike, We retrofitted all of our waves with USI spray fluxers. We are running no-clean on 4 of our waves, and OA 2331-ZX, reduced specific gravity to .825, on the other 2 With OA you must buy a special spray head to accomadate higher pressure and l
Electronics Forum | Mon Mar 22 04:14:36 EDT 2010 | mun4o
Sorry,I saw 'ShoRate' gauge at the back of the machine.Yes, when fluxer working, the ball moving.But from fluxer head flow only air.
winsouce.jpg)